Loading ...
Loading ...
Loading ...
49-3000291 Rev 4 5
Getting started
USING THE WASHER
Throughout this manual, features and appearance may vary from your model.
Controls
• Loosely add items.
Overloading may
negatively impact wash
performance. See page 11
for suggested loading
examples.
• Close door.
NOTE: Washer will not
start with door open.
Step 2 Step 3
Step 4
Step 1
• If the screen is dark, press the Power
button to “wake up” the display.
• Select a wash cycle. (Defaults are set for
each wash cycle. These default settings
can be changed. See Control settings
for more information.)
• Press the
Start/Pause
button.
• Add fabric softener to the fabric
softener dispenser; see page 10.
• Add the manufacturer’s
recommended amount of
detergent.
GE Appliances
recommends
the use of High
Efficiency
detergents such as in
your energy efficient
washer.
Place
detergent pods in the bottom of the
wash basket before adding clothes.
To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY
INFORMATION before operating this appliance.
WARNING
Power
Start
Pause
MAX
Liquid Only
MAX
Sanitize
Temp RinseSpin PreWashMy Cycle
DelayNormal
Extra
Cold
Cool
Warm
Ex Hot
Hot
No Spin
Low
Medium
Max
High
Door
Locked
Ex Light
Light
Normal
Ex Heavy
Heavy
FILL WASH RINSE SPIN
Est Time Remaining
PreWash
My Cycle
Power
Start
Pause
Quick Wash
Delicates
Normal
Whites
Heavy
Duty
Cold Wash
Active
Wear
Casuals
Towels
Casuals
With Steam
Stain Wash
With Steam
Rinse + Spin
Tub Clean
Soil
Delay
Wash
Hold to Set
C
K AJBL
D E F G H I
A
Power
Press to “wake up” the display. If the display is active, press to put the washer into standby mode.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
(Appearance
will vary)
Display and Status Lights
The display shows cycle status (
FILL WASH RINSE SPIN
), the Estimated Time Remaining until the end of the
cycle and the options selected. In addition, the display will show:
Controls locked on.
End of cycle signal on.
Indicates Delay Wash set time is selected.
NOTE: If an out-of-balance condition is detected by the washer, the SPIN light will blink during the remaining portion
of the cycle and will stay illuminated for a short time after cycle completion. When this occurs, the washer is taking
actions to correct the out-of-balance condition and complete the cycle normally. In some cases, the washer may
not be able to balance the load and spin up to full speed. If you notice the load is more wet than usual at the end of
the cycle, redistribute the load evenly in the wash tub and run a drain and spin cycle. Select Rinse+Spin cycle and
select no rinse by pressing Rinse until both Extra and Normal lights turn off.
Loading ...
Loading ...
Loading ...