Loading ...
Loading ...
Loading ...
HOW TO CLEAR
A CLOGGED DISCHARGE CHUTE
,_ WARNING: Hand contact
with the rotating impeller in-
side the discharge chute is
the most common cause of injury as-
sociated with snow throwers. Never
use your hand to clean out the dis-
charge chute.
To Clear The Chute:
• SHUT OFF THE ENGINE!
• Wait 10 seconds to be sure that the
impeller blades have stopped ro-
tating.
• Always use a clean-out tool, not
your hands.
Use a clean-out tool to remove snow
from the auger housing.
• Release the auger drive lever.
• Pull out the key.
• Disconnect spark plug wire.
• Do not place your hands in the au-
ger or discharge chute. Use a
clean-out tool to remove snow or
debris.
,_ WARNING: Blockage must
be cleared only after shut-
ting off the snow thrower
and only with a clean-out tool, not
by hand.
SNOW THROWING TIPS
1. When the handle is raised, the au-
ger blades will engage the ground
and the snow thrower will move for-
ward. When the auger drive lever is
released, the auger blades will stop.
If the blades do not stop, see "How
To Adjust The Auger Drive Cable" in
the Service And Adjustment section.
2. Most efficient snow throwing is ac-
complished when the snow is re-
moved immediately after if falls.
3. For complete snow removal, slightly
overlap each previous path.
4. Whenever possible, discharge the
snow down wind.
5.
6.
The distance the snow will be dis-
charged can be adjusted by moving
the discharge chute deflector. Raise
the deflector for more distance or
lower the deflector for less distance.
In windy conditions, lower the chute
deflector to direct the discharged
snow close to the ground where it is
less likely to blow into unwanted
areas.
7. For safety and to prevent damage
to the snow thrower, keep the area
to be cleared free of stones, toys 2.
and other foreign objects.
1741476 14
8. When clearing snow from crushed
rock or gravel driveways, do not al-
low the auger blades to contact the
driveway. Move the handle down to
slightly raise the auger blades.
9. The forward speed of the snow
thrower is dependent on the depth
and weight of the snow. Experience
will establish the most effective
method of using the snow thrower
under different conditions.
10. After each snow throwing job, allow
the engine to run for a few minutes.
The snow and accumulated ice will
melt off the engine.
11. Clean the snow thrower after each
use.
12. Remove ice, snow and debris from
the entire snow thrower. Flush with
water to remove all salt or other
chemicals. Wipe snow thrower dry.
DRY AND AVERAGE SNOW
1. Snow up to eight inches deep can
be removed rapidly and easily by
walking at a moderate rate. For
snow or drifts of a greater depth,
slow your pace to allow the dis-
charge chute to dispose of the snow
as rapidly as the auger receives the
snow.
Plan to have the snow discharged in
the direction the wind is blowing.
Loading ...
Loading ...
Loading ...