Loading ...
Loading ...
Loading ...
ASSEMBLY
CAUTION:
Do not attempt assembly if parts are missing.
Use this manual to order replacement parts. Be certain all
parts are clean and free of shipping preservative. Also, com-
pletely remove all parts of packing. Saw cabinet should be
assembled directly on the oor.
SAW INSTALLATION
Positioning the saw on a level surface will improve stability
and accuracy and prevent warpage and failure of cast com-
ponents and welds.
WARNING:
Make certain that the saw is disconnected from
the power source.
INSTALL HANDWHEELS
Refer to Figure 3.
• Remove saw cabinet and place upside down on cardboard
box or cardboard on oor.
• Place one of the handwheels onto the blade raise/lower
shaft located on the front of the cabinet. Align the groove
in the back of the handwheel with the pin.
• Thread the washer and locking knob onto the threaded end
of the shaft. Do not overtighten or handwheel will not turn.
• Repeat the steps above to assemble the remaining hand
wheel and locking knob onto the blade tilt shaft located on
the side of the cabinet.
Handwheel
Cardboard
Flat Washer
Locking Knob
Figure 3
REMOVE PACKING MATERIAL
Refer to Figure 4.
• Use the blade height handwheel to lower the motor.
• Remove the packing material from behind the motor.
• Return motor to the raised position.
ASSEMBLE MOBILE BASE PANELS
Refer to Figure 5.
Tools Required:
4mm Hex Wrench.
Hardware Required:
Twenty-four M6 x 12 socket pan head
screws (Hardware bag #4).
• Attach a corner support to each front panel edge with three
M6 x 12 socket pan head screws.
NOTE:
Place the panel edges INSIDE the corner support
surfaces.
NOTE:
Front panel and rear panel are both stamped ‘A’.
Front panel has warning label.
• Repeat above step for the rear panel.
Figure 5
Panel B (left)
Panel A (rear)
Panel A (front)
Panel C (right)
M6 x 12 Socket
Pan Head
Screws (x24)
• Turn all panels upside down to perform base assembly.
• Attach one corner of left panel (stamped ‘B’) to front panel
A.
• Attach the other corner of left panel B to rear panel A.
• Repeat above two steps for attachment of right panel
(stamped ‘C’).
ASSEMBLE CASTER SETS
Refer to Figures 6 & 7.
Tools Required:
One 6mm Hex wrench and one 13mm
Open End or Adjustable Wrenches.
• Remove casters (4), link plate and caster supports (2) from
carton.
Figure 6
Casters
Link Plate
Caster Support (rear)
Caster Support (front)
Figure 4
Packing Material
6
Loading ...
Loading ...
Loading ...