Loading ...
Loading ...
Loading ...
10
Trunnion Bolts (x4)
Figure 18
• Tighten the four trunnion hex head bolts and lock washers
securely.
This procedure will set the table and blade in parallel
position and prevent the trunnion from shifting.
NOTE:
If you perform this adjustment, leave the back panel
o to perform rear rail assembly as described in the next
section.
RAIL ASSEMBLY
Refer to Figures on Pages 10 and 11.
Tools Required:
13mm Open end Wrench
Hardware Required:
Sixteen M8 x 30 hex head bolts,
sixteen 8mm lock washers, sixteen 8mm at washers and
sixteen M8 hex nuts. (Hardware bag #2).
Figure 19
RAIL ASSEMBLY Cont.
Refer to Figures on Pages 10 and 11.
NOTE:
For this procedure the longer rail is installed to the
right; the shorter rail is installed to the left.
• Assemble the left front rail to the right front rail. Slide the
protruding pins from the left rail into the pin slots of the right
rail.
• Insert four M8 x 30 hex head bolts into the T-slot of the right
front guide rail.
• Insert four M8 x 30 hex head bolts into the T-slot of the left
front guide rail.
• Attach the assembled front rail to the table casting and to
the right and left table extensions using at washers, lock
washers and hex nuts.
M8 x 30 Hex
Head Bolts
M8 Flat & Lock
Washers
M8 Hex
Head Nut
NOTE:
Hand tighten all hardware during rail assembly. Do
not completely tighten hardware until all rails are mounted.
NOTE:
You may have to shift right rail as far right as it will go
to attach left rail.
• Position rails so that rails are butted together and the joint
between rails is aligned with right side of the blade. You
may need a mallet to lightly tap rails together. Make sure
rails are completely butted together at the joint.
Figure 20 Straight Edge
Rail
Joint
• To allow for attachment of rear rails, loosen and remove the
six socket pan head screws and back panel. Figure 23,
page 11.
• Install and level the rear rails in the same manner as the
front rails. Use a straight edge to align the left edge of rail
joint to the blade. Figure 22, page 11.
• Before proceeding, ensure all hardware is tightly secured.
• Replace back panel of the cabinet. Figure 23, page 11.
• Use a straight edge to align right edge of rail joint to blade.
Fully tighten right rail.
• Use a level to check level and atness between right and
left rail. When level, fully tighten left rail.
• Before proceeding, ensure all hardware is tightly secured.
Figure 21
Check Gap
Along Rail
Short Rail
(Left)
Long Rail
(Right)
Loading ...
Loading ...
Loading ...