Loading ...
Loading ...
Loading ...
8
After unpacking the oven,
make sure that it has not been
damaged during transit and
that the oven door closes
properly.
In the event of problems,
contact the dealer or your
nearest After-Sales Service. To
avoid any damage, only
remove the oven from its
polystyrene foam base at the
time of installation.
Preparing the housing unit
• Kitchen units in contact
with the oven must be heat
resistant (min 90°C).
• Carry out all cabinet
cutting work before fitting
the oven in the housing and
carefully remove all wood
chips and sawdust.
• After installation, the bottom of the oven must no longer be accessible.
• For correct appliance operation, do not obstruct the minimum gap between the worktop and the
upper edge of the oven.
Electrical connection
Make sure the power voltage specified on the appliance dataplate is
the same as the mains voltage. The dataplate is on the front edge of
the oven (visible when the door is open).
• Power cable replacement (type H05 RR-F 3 x 1.5 mm
2
) must be
carried out by a qualified electrician. Contact an authorized
service centre.
GENERAL RECOMMENDATIONS
Before use:
• Remove cardboard protection pieces, protective film and adhesive labels from the oven and the
accessories.
• Remove the accessories from the oven and heat it at 200°C for about an hour to eliminate the smell
and fumes from the protective grease and insulating materials.
During use:
• Do not place heavy objects on the door as they could damage it.
• Do not cling to the door or hang anything from the handle.
• Do not cover the inside of the oven with aluminium foil.
• Do not pour water into the inside of a hot oven; this could damage the enamel coating.
• Do not drag pots or pans across the bottom of the oven as this could damage the enamel coating.
• Make sure that the electrical cables of other appliances do not touch hot parts of the oven or become
trapped in the door.
• Do not expose the oven to atmospheric agents.
Installation
Loading ...
Loading ...
Loading ...