Loading ...
Loading ...
Loading ...
6 Specifications subject to change without notice. OM-40MAQ-07
REMOTE CONTROL
IMPORTANT:
The remote control can operate the unit from a distance
of up to 26 ft. (8 m) as long as there are no obstructions. When the timer
function is used, the remote control should be kept in the vicinity of the
fan coil (within 26 ft. / 8 m).
The remote control can perform the following basic functions:
• Turn the system ON and OFF
• Select the operating mode
• Adjust room air temperature set point and fan speed
• Adjust right-left airflow direction
Refer to the “INDOOR UNIT DISPLAY INDICATOR” on page 3 for
a detailed description of all the capabilities of the remote control.
Battery Installation
Two AAA 1.5v alkaline batteries (included) are required for remote
control operation.
To install or replace batteries:
1. Slide the back cover off the control to open the battery
compartment.
2. Insert the batteries. Follow the polarity markings inside the battery
compartment.
3. Replace the battery compartment cover.
NOTES:
1. When replacing batteries, do not use old batteries or a different type
battery. This may cause the remote control to malfunction.
2. If the remote is not going to be used for several weeks, remove the
batteries. Otherwise, battery leakage may damage the remote
control.
3. The average battery life under normal use is about 6 months.
4. Replace the batteries when there is no audible beep from the indoor
unit or if the Transmission Indicator fails to light.
5. When batteries are removed, the remote control erases all
programmed settings. The control must be reprogrammed after the
insertion of new batteries.
Remote Control Operation - Quick Start
NOTE: When transmitting a command from the remote control
to the unit, be sure to point the control toward the right side of the
unit. The unit confirms receipt of a command by sounding an
audible beep.
1. Turn the unit on by pushing ON/OFF.
NOTE: If there is a preference for °C rather than °F (default),
press and hold the
+ and - temperature set point buttons
together for approximately 3 seconds.
2. Select the desired mode by pushing MODE.
Fig. 5 —Modes
3. Select the temperature set point by pointing the control toward the
unit and pressing the increase/decrease temperature set point
buttons until the desired temperature appears on screen.
4. Press FAN to select the desired fan speed.
NOTE: If the unit is operating in DRY or AUTO mode, the fan
speed will be automatically set.
5. Set the airflow direction. When the unit is turned on, the Up-Down
airflow louvers default to the cooling or heating position. The user
can adjust the horizontal Up-Down airflow louver position by
pushing DIRECT or have continuous louver movement by
pressing SWING.
Manual Operation
If the remote control is lost, damaged, or the batteries are exhausted,
MANUAL
can be used to run the unit. When
MANUAL
is pressed once,
the
AUTO
mode takes affect (heat or cool). When this button is pressed
twice, the system enters the
TEST
mode and runs for 30 minutes in the
COOLING
mode (it will run in the
AUTO
mode afterward). When
pressed three times, the system turns
OFF
.
Fig. 6 — Manual Button
The set conditions of manual operation are as follows:
• Preset set point: 76°F (24°C)
• Fan speed: AUTO
Discharge air direction: Pre-set position based on operation in
COOL or HEAT mode.
EQUIPMENT DAMAGE HAZARD
Failure to follow this caution may result in equipment damage. Handle the
control with care and avoid getting the control wet.
CAUTION
AUTO
COOL
DRY
HEAT
FAN
Manual Butto
n
AUTO/COOL
Loading ...
Loading ...
Loading ...