Loading ...
Loading ...
cookingsurface
Y:
_o)
8
diag.1 _-
INSTALLING THE CHIMNEY
diag.2
_:-__ BULB
diag.4
diag.3
A rubber extrusion has been provided to hide any irregularities between the cblmney and the
canopy, it is fitted by simply pushing it over the bottom visible edges of the chimney.
This steet edge may be sharp so care must be taken to avoid damage to fingers. If
desired the extrusion may be omitted from the assembly.
Remove the protective plastic film from the chimney. Prior to mounting, determine the height
required on the chimney. The height can be adjusted by changing the screw on the
back lip (diag.2). Do not tighten the screws because the chimney needs to slide up when
installing the canopy. Mount the chimney to the ceiling bracket using the screws provided.
INSTALLING THE CANOPY
Ensure the filters are removed from the canopy. Hang the canopy onto the installation bracket.
Align the canopy so it is central to the cooking surface and lines up with the chimney cover. Mark
out the position of the two safety screw holes located on the back panel. Remove the canopy, drill
the safety screw holes and fit wall plugs. Refit the canopy to the wall and secure using the
appropriate mounting screws (diag3). Remove the protective plastic film from the canopy and
filters. Refit the filters to the canopy.
CONTROL PANEL
® ii ill O
Fan On/Off Mid Speed High Speed Delay Switch Light On/Off
Delay switch - Fan will remain on at low, mid or high speed for 5 minutes before switching off
automatically.
CLEANING INSTRUCTIONS
Care and attention should always be taken when cooking with oils, alcohol_ etc, which give off
flammable vapours. Pre-used oil is especially dangerous in this respect. Do not use an
uncovered electrical grill. Particular care must be taken with grease filters which must be
periodically cleaned_ at least every two months. Remove the grease filters and wash them
either by hand or in the dishwasher using mitd detergent. Use lukewarm water and mild
detergent to clean stainless steel/iridium components. In high humidity and coastal environments_
cleaning should be camed out frequently. CAUTION: Never use abrasive or oit based liquid cleaners.
LIGHT REPLACEMENT (See diag. 4)
Disconnect the power to the rangehood. Using a small bladed screwdriver prise off the light coven If
the bulb is hot use a cloth to remove the bulb. Replace with a new bulb using a cloth. Do not
touch the new bulb with your fingers as the grease from your fingers will crack the bulb when it is
switched on. "Snap" the cover back in place. A halogen bulb 12Volt/20Watt is required.
For other accessories, parts or service, please contact your local supplier (Refer to the Warranty
Certificate).
Loading ...