Loading ...
Loading ...
Loading ...
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have nished.
34
3.3 To Remove the Electronic Timer
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Pull o the timer control button(s) and remove the control panel
(see 1.2).
Remove the timer/mounting bracket assembly from the control
panel by removing the xing screws.
Remove the timer from its mounting bracket by depressing the
plastic lugs on the timer case, at the same time pulling the unit
forward.
Reassemble in reverse order. When replacing the leads, refer to the
wiring diagram in this manual.
Check the operation of the timer.
4 Grill
4.1 To Replace the Grill Controller
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the control panel (see 1.2) and hotplate top (see 2.1).
Disconnect the wiring from the controller. Remove the 2 screws
holding the controller to the mounting panel. Fit the new controller
and reassemble in reverse order. Check for correct operation.
4.2 To Remove the Grill Element
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove grill pan from inside the grill compartment; remove the
enamelled front shield from the grill roof, by undoing the 2 screws
and washers.
Remove the 2 screws and washers securing the grill element front
support. Remove the screws from the grill element.
Lift the element out carefully, disconnecting the leads from the
element terminals (noting their position).
If it is not possible to disconnect the leads in this way, pull the
cooker forward to gain access to the rear, remove the screws
securing the electric cover to the back sheet, remove the cover and
disconnect the terminals from the rear.
Fit the new element and reassemble in reverse order.
Check the operation of the grill.
5 Ovens
5.1 To Replace an Oven Thermostat
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove control panel (see 1.2) and hotplate top (see 2.1). Open the
oven door and remove the oven furniture.
For the right-hand oven, remove the oven roof. Remove the
thermostat phial cover (2 screws). Unclip the thermostat phial from
the clips in the oven back.
For the left-hand oven, remove the 2 screws holding the thermostat
phial to the oven fan cover at the rear of the oven. Pull the unit
forward to access the rear of the cooker. Remove both rear cover
boxes by removing the xing screws and lifting clear.
Feed the thermostat capillary clear of the oven. Disconnect the
wires from the thermostat and undo the 2 xings that secure the
control to the mounting plate. Fit the replacement and reassemble
in reverse order. Make sure that the phial is clipped to the oven rear,
positioned centrally between the clips.
Check the operation of the thermostat.
Loading ...
Loading ...
Loading ...