Craftsman 358796121 line trimmer

User Manual - Page 12

For 358796121.

PDF File Manual, 22 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Check oil level before each use. Add
oil if needed. Fill to FULL line on dip-
stick. Change oil after first 4 hours of
use, then every 8 hours of operation
or each season (see CHANGE ENGINE
OIL in the MAINTENANCE section).
Change oil every 4 hours when oper-
ating the engine under heavy load or
in high temperatures. You may need
to change the oil more often under
dusty, dirty conditions.
ADD GASOLINE
Use fresh, clean, regular unleaded gas-
oline with a minimum of 87 octane. Do
not mix oil with gasoline. Purchase
fuel in quantities that can be used within
30 days to assure fuel freshness.
IMPORTANT
Alcohol blended fuels (called gaeohol
or using ethanol or methanol) can at-
tract moisture which leads to separa-
tion and formation of acids during stor-
age. Acidic gas can damage the fuel
system of an engine while in storage.
To avoid engine problems, empty the
fuel system before storage for 30 days
or longer. Drain the gas tank, start the
engine and let it run until the fuel lines
and carburetor are empty. Use fresh
fuel next season.
Never use engine or carburetor cleaner
products in the fuel tank or permanent
damage may occur.
See the STORAGE section for additional
information.
&WARNING: Fill to bottom of gas
tank filler neck. DO NOT overfill. Wipe
off any spilled fuel. Do not store, spill
or use gasoline near an open flame.
_I_WARNING: Allow engine to cool
for 2 minutes before removing fuel cap
for refueling. Remove fuel cap slowly.
1. Tilt engine in angle shown to prop-
erly fill fuel tank.
_'F'FFuelfill
2. Remove fuel cap by turning coun-
terclockwise. Fill tank to bottom of
tank filler neck.
3. Replace fuel cap before starting.
HOW TO STOP YOUR UNIT
To stop the engine, move the ON/
OFF switch to the OFF position.
If engine does not stop, move red
choke lever to FULL CHOKE position.
ON/OFF SWITCH
HOW TO START YOUR UNIT
O f you are starting
your engine for the
FIRST time, follow
the steps listed in
the STARTING A
NEW ENGINE
section.
A _______
41_WARNING: Avoid any contact
with the muffler. A hot muffler can
cause serious burns.
Starting Position
Choke Lever Muffler
Throttle
Trigger
Prime
Bulb
STARTING A NEW ENGINE
NOTE: Add oil and fuel as instructed
in this manual prior to attempting to
start engine (see ADD OILand ADD
GASOLINE sections).
1. Set unit on a flat surface.
2. Slowly press the primer bulb 15
times.
3. Move red choke lever to FULL
CHOKE position.
4. Squeeze the throttle trigger fully and
hold through all remaining steps.
12
Loading ...
Loading ...
Loading ...