Loading ...
Loading ...
Loading ...
11
ENGLISH
Accessories
WARNING: Since accessories, other than
those offered by CRAFTSMAN, have not been tested
with this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with thisproduct.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call 1-888-331-4569.
2. Press the release tabs
19
on the spool cap
18
, and
remove the spool cap from the spool housing
10
(Figure K).
3. For best results, replace spool with CRAFTSMAN Model
# CMZST065.
4. If lever in base of housing becomes dislodged,
replace in correct position before inserting new spool
intohousing.
5. Remove any dirt and grass from the spool cap and
spool housing.
6. Unfasten the end of the cutting line and guide the line
into the eyelet.
7. Take the new spool and push it onto the boss
20
in the
housing. Rotate the spool slightly until it is seated.
8. The line should protrude approximately 5-3/8"
(136mm) from the housing.
9. Align the release tabs on the spool cap with the slots in
the spool housing.
10. Snap the spool cap back on by depressing release tabs
and pressing into spoolhousing.
11. Push the cap onto the housing until it snaps securely
intoplace.
Fig.L
20
NOTE: Make sure that cover is fully positioned, listen for
two audible clicks to ensure both release tabs are correctly
located. Power the appliance on. In a few seconds or less
you’ll hear the nylon line being cut automatically to the
proper length.
NOTE: Other replacement parts (guards, spool caps, etc.) are
available through authorized service centers. To find your
local service location call: 1-888-331-4569 or visit
www.craftsman.com.
Rewinding Spool from Bulk Line (use only
.065" (1.65 mm) ROUND diameter line)
(Fig. A, M, N)
Bulk line is also available for purchase from your local
retailer. NOTE: Hand wound spools from bulk line are likely
to become tangled more frequently than CRAFTSMAN
factory wound spools. For best results, factory wound spools
are recommended.
1. Remove battery from appliance.
2. Remove the empty spool from the appliance as
described in Replacing Spool Assembly.
3. Remove any remaining cutting line from the spool.
4. Make a fold at the end of the cutting line at about 3/4"
(19 mm)
21
. Feed the cutting line into one of the line
anchoring slots
22
.
5. Insert the 3/4" (19 mm) end of the bulk line into the
hole
23
in the spool adjacent to the slot. Make sure the
line is pulled tight against the spool.
6. Wind the cutting line onto the spool in the direction of
the arrow on the spool. Make sure to wind the line on
neatly and in layers. Do not crisscross.
7. When the wound cutting line reaches the recesses
24
cut the line.
8. Fit the spool onto the appliance as described in
Replacing Spool Assembly.
Fig. M
22
21
23
24
Fig.N
MAINTENANCE
WARNING: To reduce the risk of
serious personal injury, turn unit off and
remove the battery pack before making any
adjustments or removing/installing attachments
or accessories, when replacing line, or prior to
cleaning. An accidental start-up can causeinjury.
Loading ...
Loading ...
Loading ...