Loading ...
Loading ...
Loading ...
9. Removethearborbolt(6),theblade
collar(7),andtheblade(8).Donot
removetheinnerbladecollar.
(Fig.M)
10.Raisethelowerclearplasticblade
guard(4)totheuprightpositionto
removetheblade.(Fig.K)
NOTE:Payattentiontothepieces
removed,notingtheirpositionandthe
directiontheyface.Wipetheblade
collarscleanofanysawdustbefore
installinga newblade.Also,the12in.
bladehasa 1in.arborholewitha 5/8in.
reducer(9)tomountontothesaw.
Fig.M
9
Installing Blade (Fig. K, L, M)
i_lk WARNING]
Un=plug the miter saw before
changing/installing the blade.
1. Install a 12 in. blade with a 5/8 in.
arbor (or a 1 in. arbor blade with
a 5/8 in. reducer) making sure the
rotation arrow on the blade matches
the clockwise rotation arrow on the
upper guard, and the blade teeth
are pointing downward.
2. Place the blade collar (7) against
the blade and on the arbor. Thread
the arbor bolt (6) on the arbor in a
counterclockwise direction. (Fig. M)
iMPORTANT: Make sure the flats of
the blade collars are engaged with
the flats on the arbor shaft. Also, the
flat-side of the arbor collar must be
placed against the blade.
3. Place the blade wrench on the arbor
bolt (6).
4. Press the arbor lock button (5),
holding it in firmly while turning
the blade counterclockwise. When
it engages, continue to press the
arbor lock button in, while tightening
the arbor bolt securely. (Fig. L)
5. Rotate the cover plate (3) back to its
original position until the slot in the
cover plate engages with the upper
cover plate screw (1) and lower cover
plate screw (2). While holding the
lower blade guard, tighten the screw
with a Phillips screwdriver. (Fig. K)
NOTE: The lower blade guard must
be raised to the upright position to
access the cover plate screw.
6. Lower the clear retractable blade
guard (4) and verify the operation of
the guard does not bind or stick
(Fig. K).
7. Be sure the arbor lock is released
so the blade turns freely by spinning
the blade until the arbor lock
disengages.
I WARNINGI
o To avoid injury, never use the
saw without the cover plate
secure in place. It keeps the
arbor bolt from falling out if it
accidentally loosens, and helps
prevent the spinning blade from
coming off the saw.
o Make sure the collars are clean
and properly arranged. Lower the
blade into the table and check for
any contact with the metal base
or the saw table.
Loading ...
Loading ...
Loading ...