INSTALLATION
WHERE TO PUT YOUR DRYER
10
m
m
15 mm
15 mm
15 mm
15 mm
If you are going to install the
appliance under a work counter be
sure to leave a 10mm space
between the top and any other
objects on or above the machine
and a 15mm space between the
sides and any kitchen units or walls
to ensure proper air circulation. The
dryer must never be installed behind a lockable door, a
sliding door or a door with a hinge on the opposite side
to that of the dryer door.The appliance must be installed
with the rear surface placed against a wall.
VENTILATION
When the dryer is in use there has to be adequate ventilation to avoid
the back ow of gases into the room from appliances burning other
fuels, including open res.
The vent tube should not exceed 2.4 metres in length.
The tube should be kept clear of the air intake vent and kinks or ‘U’ bends
must be avoided as these will obstruct the tube and trap condensation.
VENTING
Wall mounting
Keep the tube as short and as straight as
possible to prevent condensation forming
in the vent pipe.
The duct in the wall should slope slightly
downwards.
Mounting
The hole should be as low down as
possible and the tube should be kept as
short as possible. Depending on how often you use your tumble dryer, it
is essential that areas A and B are checked periodically to remove lint or
debris.
Make sure that the ventilation hose, air inlet vents, and outlets are not
obstructed or blocked.
Venting
The end of the tube should be directed downwards, to prevent warm
moist air from condensing in the room or dryer.
Do not discharge exhaust air into a ue which is used for exhaust
fumes from other appliances that burn gas or other fuels.
Do not discharge exhaust air into an extraction system or any duct with
an extractor fan. This will aect the way the thermal controls operate and
can result in a re hazard.
B
A
ELECTRICAL CONNECTIONS
The socket must be grounded. The power supply cord
should be checked periodically. If the supply cord is
damaged, it must be replaced by the manufacturer, its
service agent or similarly qualied persons in order to
avoid a hazard
LEVELLING YOUR DRYER
The dryer must be installed level for correct
operation. When you have installed your
dryer in its nal location check that it is rst
level side to side and then back to front.
If the dryer is not level use a wooden block
to support it while adjusting the two front
legs up or down until your dryer is level.
BEFORE YOU START USING YOUR DRYER
Once you have installed your dryer and before you use
it clean the inside of the drum to remove any dust that
could have accumulated during transport.
Instruction booklet
TUMBLE DRYER
Our ideas. Your home.
Our ideas. Your home.
ITEMS NOT SUITABLE FOR TUMBLE
DRYING
1. Articles that contain rubber or rubber-like materials or plastic lm, any
ammable articles or objects that contain ammable substances.
2. Glass bres.
3. Items which have been dry cleaned.
4. Large bulky items (quilts, sleeping bags, etc). These expand when
drying and prevent airow through the dryer.
This symbol reminds you to read this booklet.
GUIDE TO FITTING THE VENT HOSE TO
YOUR DRYER
Remove ‘oval-shaped’ Ventilation
hose from the packaging.Ensure
that you also remove the two jubilee
clips.If you require to reduce the
length of the hose please wear
gloves when cutting the hose.
Pull to expand the end of the
Ventilation hose prior to fitting.
If the hose has not been expanded,
the jubilee clip will not clamp the
hose to the adaptor.
Place one of the the jubilee clips
over the end of the extended vent
hose.The second jubilee clip can be
used to secure the opposite end of
the vent hose to a wall mounting kit
(not supplied).
Clamp the ventilation hose to the
rear vent outlet by tightening the
jubilee clip with a screwdriver.
If the hose has not been expanded,
the clip will not clamp the hose to
the rear vent outlet.
The tumble dryer may protrude further forward from the worktop.
Please do not push the tumble dryer too far backwar.
Caution: Hot!
Vent Tube tted here
Air intake vent. Do not block or obstruct
Loading ...
Loading ...
Loading ...