Loading ...
Loading ...
Loading ...
7
Installation
English
B. Mounting on a wood stud wall
covered with gypsum board drywall
1. Use a stud finder to locate two adjacent
studs. Find both edges of each stud to
mark down the center lines for two studs
with a pencil.
Note: Drywall covering the wall must not
exceed 16 mm (ξξξ").
2. Place the wall plate paper template
against the wall to ensure the 4 holes line
up with the stud center lines. Level the
paper template and tape it in place.
Note: This is the drilling template to be pasted
on wall for drilling holes easily and safely.
Drill here
(24" apart)
Drill here
(24" apart)
Drill here
(16" apart)
Drill here
(16" apart)
Drill here
(24" apart)
Drill here
(24" apart)
Drill here
(16" apart)
Drill here
(16" apart)
24 in. (609.6 mm) apart
16 in. (406.4 mm) apart
Paper Template
3. Using a ΒΌ" (6mm) drill bit, drill 4 mounting
holes with the depth 3" (76mm). Then
remove the paper template.
Note: This is the drilling template to be pasted
on wall for drilling holes easily and safely.
Drill here
(24" apart)
Drill here
(24" apart)
Drill here
(16" apart)
Drill here
(16" apart)
Drill here
(24" apart)
Drill here
(24" apart)
Drill here
(16" apart)
Drill here
(16" apart)
24 in. (609.6 mm) apart
16 in. (406.4 mm) apart
4. Install the wall plate on wall using 4 lag
bolts(A) and washers (B).
Tighten the lag bolts securely and ensure
the wall plate level by using the built-in
bubble level on the mount.
CAUTION: Do not over-tighten the lag
bolts. Improper use could reduce the
holding power of the lag bolt.
Loading ...
Loading ...
Loading ...