Loading ...
Loading ...
Loading ...
SERVICE
i
TO ADJUST THE BELT GUIDES
There are two belt guides on your snowthrower Afteryou
replace an auger drive belt, you need to adjust one or
both of the belt guides (See Fig 14) Proceed as follows:
O Remove the (3) screws from the access panel on
the rear' of the top cover
@ Disconnect the spark plug wire
@ Remove the belt cover (See to Remove the Belt
Cover paragraph on page 15)
• Engage the auger control bar,
® Measure the distance between the belt guides and
the belt, The distance should be 1/8" for each guide
@ If adjustment is necessary, move the belt guides to
the correct position, (See Fig 14)
O Move the belt guides to the correct position
e Release the auger control bar,
e Reinstallthe belt cover,
e Reconnect the spark plug wire and reinstall the
access panel
TO REPLACE THE SCRAPER BLADE
If the scraper blade must be replaced due to wear,
proceed as follows (See Fig 15):
@ Remove 4 nuts, 4 bolts and scraper blade
e Install new scraper blade, 4 nuts, and 4 bolts
ADJUST TS
ii ii IINNI"IIIIIIIIIIINIHII"IIHIIHHHHHI""HH"HI ' I '
FIG,, 14
(Left Hand)
BOLTS SCRAPER
BLADE
NUTS
FIG. 15
16
Loading ...
Loading ...
Loading ...