Loading ...
Loading ...
Loading ...
SAW MOUNTED TO WORK SURFACE (FIG. C)
1. If the leg set will not be used, the saw must be
properly secured to a sturdy workbench using the
four mounting holes at the base of the saw.
2. The surface of the table where the saw is to be
mounted must have a hole large enough to facilitate
sawdust fall-through and removal.
3. Square the saw on the mounting surface and mark
the location of the four 3/8" mounting holes (1).
4. Drill 3/8" hole into the mounting surface.
5. Mark an 11" square (2) centered between the four
mounting holes (1).
6. Cut out and remove the square.
7. This opening will allow sawdust to fall through the
saw base.
8. Place the saw on the work surface, and align the
mounting holes of the saw with those drilled through
the surface.
9. Fasten the saw to the work surface.
O
Do not operate this machine on the floor. This is very
dangerous and may cause serious injury.
Fig. C
Failure to provide the sawdust fall-through hole for use
of the saw when mounted to a work surface and not the
stand will cause sawdust to build up in the motor area,
which may result in fire or cause motor damage.
Always keep your work area clean, uncluttered and well
lit.
1. If the dust bag is not used, do not work on floor
surfaces that are slippery from sawdust or wax.
2. When using the dust bag some dust will not fall into
the bag but come out through openings in the
housing. Do not cover the motor cooling vents.
INSTALLING THE DUST BAG (FIG. D)
Fig. D
//
/ / /
BLADE RAISING HANDWHEEL (FIG. E, F)
1. Attach the up ~ down handwheel (1) to the elevation
rod (2) at the front of the saw.
Make sure the slots (3) in the hub of the
handwheel engage with the pins (4).
2. Attach and tighten the dome nut (5 - Fig. F).
Fig. E
3 2 4
1
BLADE TILTING HANDWHEEL (FIG. F)
1. Attach the bevel 0° ~ 45 ° handwheel (6) to the blade
tilting rod on the right side of the saw in the same
manner as above.
2. Attach and tighten the handwheel dome nut (5).
Fig. F
Do not use this saw to cut and/or sand metals. The hot
chips or sparks may ignite sawdust or the bag material.
Place the dust bag around the neck of the dust chute
and tie the dust bag pulling the string tight and secure
with the spring-loaded tie clip.
Loading ...
Loading ...
Loading ...