Loading ...
Loading ...
Loading ...
98 - CLEANING AND MAINTENANCE 914779559/C
The indicator light comes on to indicate
the request to drain the water.
Reservoir draining
1. Open the door
2. Place the deep pan on the third shelf from
the bottom. Push it against the rear wall of
the oven cavity.
3. Press the button again to start the
function.
The water starts to flow into the deep pan from
the drain pipe on the right side of the rear wall
of the oven cavity.
4. Wait for the end of the drain flow.
At the end the appliance makes a beep and the
display shows .
5. Drain the water from the deep pan.
Extraordinary maintenance
Seal maintenance tips
The seal should be soft and elastic.
• To keep the seal clean, use a non-abrasive
sponge and wash with lukewarm water.
Replacing the internal light bulb
1. Completely remove all accessories from
inside the oven.
2. Remove the rack/tray support frames.
3. Use a tool (e.g. a spoon) to remove the bulb
cover.
4. Slide out and remove the light bulb.
5. Replace the light bulb with one of the same
type (40 W).
6. Refit the cover. Ensure the moulded part of
the glass (A) is facing the door.
7. Press the cover completely down so that it
attaches perfectly to the bulb support.
It is recommended to carry out the
cleaning process of the reservoir and
hydraulic circuit twice.
A cleaning solution can also be used
instead of water. In this case it is
advisable to carry out at least a couple
of water rinses afterwards, following the
instructions in this chapter.
Power voltage
Danger of electrocution
• Unplug the appliance.
• Wear protective gloves.
Take care not to scratch the enamel of
the oven cavity wall.
Do not touch the halogen light bulb
directly with your fingers, use an
insulating material.
Loading ...
Loading ...
Loading ...