Loading ...
Loading ...
Loading ...
Afterloading,closethedoor(donot latch).Make
cycleselectionbyturningdialclockwise.Select
WashandDryOptions.
WashandDryOpUons:
Power Dry
This pushbutton will provide heat during drying
on any wash cycle.
Temp Boost
This pushbutton will provide heat during the
main wash on any wash cycle, extending It until
the proper wash temperature is reached. The
operating light at the left of the panel, which Is
normally on while the dishwasher is running, will
go out anytime the main wash is being extended.
This is to let you know the water Is being heated.
Use of Temp Boost option will also provide for
maximum cleaning on any wash cycle.
NOTE: Power Dry or Temp Boost can be used
separately or both at the same time.
Energy Saver
This pushbutton will cancel Power Dry to
eliminate heat during dry. The fan will still
operate. This pushbutton will also cancel Temp
Boost so heat will not be added to the main
wash.
To Start:
After setting the dialon the desired cycle, start
the dishwasher by moving the latch lever to the
right as far as it will go. All cycles begin with a
pause of approximately 11/= minutes. The
operating light will come on immediately to let
you know the cycle has started. The signal light
will remain on through entire cycle except during
the water heating period of Temp Boost.
NOTE: If the dishwasher is not located near the
water heater, let the water from the hot
water tap run before starting the
dishwasher, in order to clear the line of
cold water.
To stop the dishwasher at any time, move the
door latch to the left.
To Add a Forgotten Item:
It should be added as early In the cycle as
possible for best cleaning. Stop the dishwasher
by moving the door latch to the left. Wait until
the sound of circulating water stops, then open
the door. After adding the item, close and latch
the door. The cycle will continue at the point
where it was Interrupted.
6
Loading ...
Loading ...
Loading ...