Loading ...
Loading ...
Loading ...
page 4
5. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower
hanging ball and remove stop pin and then slide
hanging ball off of the downrod. [Refer to
diagram 1.]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor
housing yoke. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod. [Refer to
diagram 2.]
Determine the length of downrod you wish to
use. Thread electrical wires through threaded end
of downrod and pull extra wire slack from the
upper end of the downrod. [Refer to diagram 2.]
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align with
holes in yoke--make sure wires do not get twisted.
Re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts
securely. [Refer to diagram 2.]
Slide weatherproof yoke cover and canopy over
downrod. [Refer to diagram 3.]
Thread wires through hanging ball; then slide
hanging ball over downrod--the top of the
downrod should be noted as having a set screw
hole; use this hole when setting the set screw.
Insert stop pin into top of downrod and raise
hanging ball. Be sure stop pin aligns with slots on
the inside of the hanging ball. Tighten set screw
securely. [Refer to diagram 4.]
WARNING: Failure to tighten set screw on
hanging ball completely could result in the fan
becoming loose and possibly falling.
["Fan Assembly" continued on next page.]
motor
housing
set screw
hanging ball
stop pin
diagram 1
diagram 2
yoke set
screw
and nut
pin
clip
downrod
electrical wiring
diagram 4
downrod
motor
housing
weatherproof
yoke cover
canopy
diagram 3
set screw hole
hanging ball
stop pin
Loading ...
Loading ...
Loading ...