Loading ...
Loading ...
Loading ...
TO REPLACE HEADLIGHT BULB
• Raise hood.
o Pull bulb holder out of the hole in the
backside of the grill.
° Replace bulb in holder and push bulb
holder securely back into the hole in the
backside of the grill.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractorto run poorly,stop running, or pre-
vent it from starting.
o Check wiring. See electrical wiring dia-
gram in the Repair Parts section of this
manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
TO REMOVE HOOD AND GRILL
ASSEMBLY
° Raise hood_
• Unsnap headlight wire connector.
o Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
° To replace, reverse above procedures.
Hood
Headlight
Wire
Connector
ENGINE
Maintenance, repair, or replacement of the
emission control devices and systems,
which are being done at the customers
expense, may be performed by any non-
road engine repair establishement or indi-
vidual. Warranty repairs must be per-
formed by an authorized engine manufac-
turer's service outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at the
factory and adjustment should not be nec-
essary. Check adjustment as described
below before loosening cable. If adjust-
ment is necessary, proceed as follows:
o With engine not running, move throttle
control lever from slow to choke posi-
tion. Slowly move lever from choke to
fast position.
° Check that holes 'W' in governor control
lever and hole in governor plate ]ine-up.
If holes "A" are not aligned, loosen
clamp screw and move throttle cable
until holes are aligned. Tighten clamp
screw securely.
Governor Governor
Control Lever Control Plate
Holes "A"
Clamp
Screw
Throttle
Cable
25
Loading ...
Loading ...
Loading ...