Loading ...
Loading ...
Loading ...
Aboutcrisper removal
Not all features are on all models.
Crisper Removal
To Remove:
These (h'awex5 can be remoxed easily b)
lifting up slighfl) while pulling tile drawer
past tile stop location.
When the door cannot be fully opened,
rein eve th e dra wet fi_rth est from th e door
fixst. Make sure the drawer closest to the
door is fifllv closed. There is a latch at the
fi'ont of the center slide rail. Push down on
the latch and slide the center slide rail, to
which tile drawer is attached, a_;ly fl'om tile
door l,[enlove the drawer
Aboutthe automatic icemaker.
A newly-installed refrigerator may take 12-24 hours to begin making ice.
Power
Switch Icemaker
!
PowerLight
Power switch model
EeelerArmin
the STOP
FeelerArroin up position
the ON down
position
Feelerarm model
Automatic Icemaker (on some models)
Tile icemaker will produce seven or eight
cubes (depending on model) per cycle--
approximately 100-130 cubes in a 24-hem"
period, depending on fl'eezer compartment
teiili)ei';ittlYe _ i'ooi/] teiili)ei';ittli'e _ ntlillbeY
of door openings and other use conditions.
There are two t)])es oficemake_: power
switch models and ti_eler am/models.
If tile refi_igerator is operated heft)re tile
water connection is made to tile icemake_;
set tile power switch to 0 (Off) or move tile
teeler am_ to tile STOP(up) position.
When tile refl_igerator has been connected
to the water SUl)l)ly, set the power switch to
tile I (on) position or move tile feeler arm to
tile ON (down) position. On I)ower switch
models, the green light will come on.
You will hear a buzzing sotmd each time
the icemaker flls with water:
Tile icemaker will fill Mth water when it
cools to approximately 15°F. A newly-
installed refrigerator may take 12 to 24
hom_ to begin making ice cubes.
Throw awm tile first tew batches of ice to
alh)w tile water line to clear
Be sm'e nothing intetTeres xfith tile sweep
of tile feeler amL
&._]/en tile bin fills to tile level of tile teeler
am_, tile icemaker will stop producing ice.
It is nomml fi)r several cul)es to be joined
together:
If ice is not used fl'equenfl> old ice cubes
will become cloud> tnste stale and shrink.
On power switch models, tile green power
light will blink if ice cubes get stuck in tile
icemaket: To correct this, set tile power
switch to 0 (Of'/) and I'eIllOVe tile cubes. Set
the power switch to / (on} to restart the
icemake_; _Mier tile icemaker has been
turned on again, there will be a delay of
about 45 minutes heft)re tile icemaker
I'eStlllles ol)elTItion.
NOTE:Inhomeswithlower-than-averagewater
pressure,youmayheartheicemakercyclemultiple
timeswhenmakingonebatchof ice.
/0
Icemaker Accessory Kit
If )our refl_igerator did not come ah'eadv
equil)l)ed with an automatic icemake_;
an icemaker accessmw kit is ax filable at
extra cost.
Check tile back of tile refl_igerator fi)r
tile specific icemaker kit needed fi)r
VOIII" model.
Loading ...
Loading ...
Loading ...