Loading ...
Loading ...
Loading ...
5
CYCLE STATUS LIGHTS
The Cycle Status Lights show the progress of a cycle.
At each stage of the process, you may notice sounds
or pauses that are different from your previous washer.
SENSING FILL
When the Start/Pause button is pressed and the Water
Level knob is set to Auto Sensing, the washer will ll and
begin sensing to determine load size and balance. Once
sensing is complete, the washer will ll to the appropriate
level for the detected load size and then begin the wash
phase of the cycle.
NOTE: Sensing and wash phases will be paused by
opening the unlocked lid. Close the lid to resume the
cycle. If the lid is left open for more than 10 minutes,
the washer will cancel the cycle and pump out the water.
The lid will lock after the wash phase to begin the initial
spinout and remain locked for the remainder of the cycle.
WASH
The washer will ll to the correct water level based
on the load size and the Water Level selection. Certain
cycles may agitate during the ll process to boost
cleaning. You will hear the agitator rotate followed by
a pause lasting several seconds. When the wash cycle
begins, you will hear the agitator increase speed. The
motor sounds may change at different stages in the wash
cycle while the washer performs different wash actions.
7
RINSE
Certain cycles use a spray rinse, which adds water to
the tub while the basket spins. On some models: When
a fabric softener option is selected, you will hear sounds
similar to the wash cycle as the washer rinses and moves
the load. You may hear the motor turning on briey (short
hum) to move the basket while lling.
SPIN
The washer spins the load at increasing speeds for
proper water removal based on the selected cycle
and spin speed.
DONE
Once the cycle is complete, this light will come on.
For best results, remove the load promptly.
LID LOCKED
The Lid Locked feature allows for higher
spin speeds. When lit, the lid is locked
and cannot be opened without pausing
the cycle. When the light is off, the lid
can be opened.
To open the lid after it has been
locked, press the START/PAUSE
button. The lid will unlock once the
washer movement has stopped. This
may take several minutes if the load was
spinning at high speed. Press the START/
PAUSE button while the lid is closed to resume the cycle.
Loading ...
Loading ...
Loading ...