Loading ...
Loading ...
Loading ...
Installing Blade (Fig. K, L, M)
Unplug the miter saw before changing/
installing the blade.
1. Install a 10 in. blade with a 5/8 in.
arbor, making sure the rotation arrow
on the blade matches the clockwise
rotation arrow on the upper guard
and the blade teeth are pointing
downward.
2. Place the outer blade collar (8)
against the blade and on the arbor.
Thread the arbor bolt (6) onto the
arbor (Fig. M) in a counterclock_se_
direction.
IMPORTANT: Make sure the flats
of the blade collars are engaged with
the blade into the lower table
and check for any contact with
the base or the miter table by
spinning the blade manually.
THE LASER GUIDE (FIG. N)
,_,WARNING
Make the ON/OFF switch childproof.
Insert a padlock, or chain with
padlock, through the holes (2) in
the trigger switch, locking the tool'
S switch, preventing children and
other unqualified users from turning
the machine on.
the flats on the arbor shaft. " 1. To turn laser on, press on/off rocker
...... switch (1) to "ON" position.
3. Place the blade wrench On the arbor
bolt ....
4. Press the arbor lock (5), holding
it in firmly while turning the blade
counterclockwise. When arbor lock
engages, continue to press it in while
tightening the arbor bolt securely.
5. Rotate the cover plate (3) back to its
original position until the slotin the
cover plate engages with the cover
plate screw (2). While holding the
lower blade guard, tighteh the screw
with a Phillips screwdriver. (Fig.'K)
NOTE: The lower blade guard must
be raised to the upright position to
access the cover plate screw.
6. Lower the blade guard (1) and verify
that the operation of the guard does
not bind or stick. (Fig. K)
7. Be sure the arbor lock is released so
the blade turns freely.
[ WARNINGI
® To avoid injury, never use the saw
without the cover plate secure
in place. It keeps the arbor bolt
from falling out if it accidentally
loosens, and helps prevent the
spinning blade from coming off
the saw.
® Make sure the collars are clean
and properly arranged. Lower
22
2. To turn off laser, press on/off rocker
switch (1) to "OFF" position.
Fig. N
2
Your tool is equipped with the Laser
Trac®cutting guide using a Class Ilia
laser beam. The laser beam allows you
to preview the saw blade path on the
stock to be cut before starting the miter
saw. This laser guide is powered by the
transformed alternating current supply
directly through the power lead. The
saw must be connected to the power
source and the laser on/off switch
must be turned on for the laser line
to show.
NOTE:
® All the adjustments for the
operation of the laser guide has
been completed at the factory.
T'I
Loading ...
Loading ...
Loading ...