Loading ...
Loading ...
Loading ...
en
56
The indicator can only be reset by
pressing the reset button after the light
has come on. Pressing the button at
any other time will have no effect.
When to replace the battery in the ra-
dio-control handle
Change the battery approximately every
18 months. One 3V battery (CR2032)
is required.
The vacuum cleaner can still be used
when the battery has run out or if
there is no battery fitted.
Switch the vacuum cleaner on using
the On/Off footswitch (Fig. 24).
The standby indicator on the vacuum
cleaner will light up yellow.
Press the restart button on the va-
cuum cleaner (Fig. 43).
The vacuum cleaner can continue to be
used, but only at maximum suction
power.
Keep batteries out of the reach
of children.
A swallowed battery can cause injury
and even death. Even flat batteries
can still be dangerous. If you suspect
a child has swallowed a battery, seek
medical advice immediately*. Exam-
ine devices and make sure the bat-
tery compartment is correctly se-
cured, e.g. that the screw or other
mechanical fastener is tightened. Do
not use if compartment is not secure.
* Australia: Poisons Information
Centre, Tel. 13 11 26;
NZ: National Poisons Centre,
Tel. 0800 764 766
How to change the battery in the ra-
dio-control handle (Fig. 44)
Undo the screw on the battery com-
partment cover using a cross-tip
screwdriver and then remove the
cover.
Replace the battery with a new one.
Make sure the polarity is correct.
Replace the cover and tighten the
screw back up again.
Dispose of the old battery in a muni-
cipal recycling facility.
When to replace the battery in the
LED handle
Replace the batteries when necessary.
3 1.5V batteries (AAA) are required.
How to change the battery in the LED
handle (Fig. 06+07)
Loosen the screw on the cover.
Press in the sides of the cover to re-
lease the retainers and remove the
cover.
Take out the battery holder and in-
sert the 3 batteries supplied. Make
sure the polarity is correct.
Refit the battery holder. Arrows are
marked on the battery holder and
battery compartment as a fitting aid.
They should point in the same direc-
tion.
Replace the cover and tighten the
screw back up again.
Loading ...
Loading ...
Loading ...