Loading ...
Loading ...
Loading ...
4
NOTE
It is VERY IMPORTANT for your appliance
to be level in order to function properly. If the
unit is not leveled during installation, the door/
lid may be misaligned and not close or seal
properly, causing cooling, frost or moisture
problems.
NOTE
The exterior walls of the unit may become
quite warm as the compressor works to
transfer heat from the inside. Temperatures
as much as 30° F warmer than room
temperature can be expected. For this reason
it is particularly important in hotter climates
to allow enough space for air circulation
around your appliance.
Leveling
The appliance must have all bottom corners
resting rmly on a solid oor. The oor must be
strong enough to support a fully loaded unit.
This Use & Care Guide provides general operating
instructions for your model. Use the unit only
as instructed in this Use & Care Guide. Before
starting the unit, follow these important
rst steps.
Location
Choose a place that is near a grounded
electrical outlet.
For the most efcient operation, the appliance
should be located where surrounding
temperatures will not exceed 110°F (43°C).
Temperatures of 32°F (0°C) and below will
NOT affect operation. Additional compressor
heaters are not recommended.
Allow space around the unit for good air
circulation. Leave a 3 inch (75 mm) space on
all sides of the unit for adequate circulation.
CAUTION
To allow door to close and seal properly, DO
NOT let food packages extend past the front
of shelves.
3” (75 mm)
3” (75 mm)
3” (75 mm) Air Space
3” (75 mm)
To level Upright Units:
After discarding crating screws, use a
carpenter’s level to level the appliance from
front to back. Adjust the plastic leveling feet in
front, ½ bubble higher, so that the door closes
easily when left halfway open.
FIRST STEPS
Loading ...
Loading ...
Loading ...