Loading ...
Loading ...
Loading ...
page 4
5. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower
hanging ball and remove stop pin and then slide
hanging ball off of the downrod. [Refer to
diagram 1.]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor
housing yoke. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod. [Refer to
diagram 2.]
Determine the length of downrod you wish to
use.Thread safety cable and electrical wires
through threaded end of downrod and pull extra
wire slack from the upper end of the downrod.
[Refer to diagram 2.]
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align with
holes in yoke--make sure wires do not get twisted.
Re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts
securely. [Refer to diagram 2.]
Locate canopy cover and anti-sway adapter in
hardware packs. Slide yoke cover, canopy cover,
anti-sway adapter and canopy over downrod.
[Refer to diagram 3.] (Note: Canopy cover must
be turned with shiny side toward motor housing.
If using the anti-sway adapter, it must be turned
with wider end toward the canopy.)
Thread safety cable and wires through hanging
ball; then slide hanging ball over downrod--the
top of the downrod should be noted as having a
set screw hole; use this hole when setting the set
screw. Insert stop pin into top of downrod and
raise hanging ball. Be sure stop pin aligns with
slots on the inside of the hanging ball. Tighten
set screw securely. [Refer to diagram 4.]
WARNING: Failure to tighten set screw (on
hanging ball) completely could result in the fan
becoming loose and possibly falling.
["Fan Assembly" continued on next page.]
set screw
hanging ball
stop pin
set screw hole
hanging
ball
stop pin
diagram 1
diagram 3
diagram 4
diagram 2
canopy
motor
housing
yoke cover
downrod
yoke set screw
and nut
pin
clip
downrod
anti-sway adapter
canopy cover
Loading ...
Loading ...
Loading ...