Loading ...
Loading ...
Loading ...
35
www.spirittness.com
GENERAL MAINTENANCE
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two reasons:
a. The hardware was not sufciently tightened during assembly. All bolts that were installed during assembly need to be
tightened as much as possible. It may be necessary to use a larger wrench than the one provided if you cannot tighten
the bolts sufciently. I cannot stress this point enough; 90% of calls to the service department for noise issues can be
traced to loose hardware.
b. The crank arm nut needs to be retightened
c. If squeaks or other noises persist, check that the unit is properly leveled. There are 2 leveling pads on the bottom of the
rear stabilizer, use a 14mm wrench (or adjustable wrench) to adjust the levelers.
ENGINEERING MODE MENU
The console has built in maintenance/diagnostic software. The software will allow you to change the console
settings from English to Metric and turn off the beeping of the speaker when a button is pressed for example.
To enter the Engineering Mode Menu, press and hold down the Start, Stop and Enter buttons. Keep holding
the buttons down for about 5 seconds and the Message Center will display Engineering Mode Menu. Press the
Enter button to access the menu below:
1. Button Test (Will allow you to test all the buttons to make sure they are functioning)
2. LCD Test (Tests all the display functions)
3. Functions (Press Enter to access settings and Up arrow to scroll)
a. Sleep Mode (Turn on to have the console power down automatically after 20 minutes of inactivity)
b. Pause Mode (Turn on allow 5 minutes of pause, turn off to have the console pause indenitely)
c. ODO Reset (Resets the odometer)
d. Units (Sets the display to readout in English or Metric display measurements)
e. Beep (Turns off the speaker so no beeping sound is heard)
f. DA Test (Tests the brake resistance)
4. Security (Allows the buttonpad to be locked to prevent unauthorized use)
Loading ...
Loading ...
Loading ...