Loading ...
Loading ...
Loading ...
SECTION 7 - MOWER ATTACHMENT SERVICE
7.1 TRANSMISSION BELT
REMOVAL/REPLACEMENT
Should it become necessary to replace the transmission
drive belt, contact an authorized SNAPPER Dealer for
service.
WARNING
DO NOT attempt any maintenance, adjustments or
service with the engine running. Stop engine. Stop
blades. Latch Traction Lock Levers. Remove key.
Disconnect spark plug wires from spark plugs and
secure wires away from spark plugs. Engine and
components are HOT. Avoid serious burns by
allowing all parts sufficient time to cool before
working on machine.
2. Place Traction Belt on Wheel Pulley followed by
Transmission Output Pulley.
3. Reinstall Fender and tighten two wing-nuts.
4. Adjust Traction Rod and Brake Rod as necessary.
Refer to Section "ADJUSTMENTS
STEERING/BRAKES and TRACTION
LEVERS/RODS".
TRACTION BELT
OUTPUT PULLEY
1. Disconnect idler arm spring.
2. Remove existing belt. Replace with new belt, part
no. 2-9118.
3. Reconnect idler arm spring. See Figure 7.1.
TRANSMISSION
IDLER BELT
ELECTRIC
CLUTCH
o
IDLER ARM
SPRING
FIGURE 7.1
7.2 TRACTION BELT REMOVAL &
REPLACEMENT
7,2,1. TRACTION BELT REMOVAL
1. STOP ENGINE! Remove two wing-nuts retaining
fender. Remove fender. See Figure 7.2.
2. Remove Traction Belt from Wheel Pulley first by
running Belt off as Wheel is turned. Remove belt
from Transmission output Pulley next.
3. Lay new Traction Belt part no. 4-6240 flat on ground
(around tire) and roll Mower Wheel over Traction Belt
removing Traction Belt from machine,
7,2,2, TRACTION BELT INSTALLATION
1. STOP ENGINE! Lay Traction Belt flat on ground in
front of Traction Wheel, roll Traction Wheel over
Traction Belt until wheel is in middle of belt.
(WHEEL PULLEY /
NOT SHOWN)
BELT COVER WING NUT
FIGURE 7.2
7.3 CUTTER DECK BELT REMOVAL &
INSTALLATION
1. Remove mower deck belt cover.
2. Remove idler spring and swing idler away from belt.
3. Remove old belt from spindle pulleys and electric
clutch pulley.
4. Route new belt, part number 3-5710 for 36" Deck &
2-9261 for 48" Deck around spindle pulleys.
NOTE: 36" Deck Belt also connects to electric clutch.
5. Move idler to belt and re-attach tension spring.
6. For 48" Deck to electric clutch use belt 2-9262.
36" DECK SHOWN
REMOVE IDLER
BELT ULLEY
FIGURE 7.3
20
Loading ...
Loading ...
Loading ...