Loading ...
Loading ...
Loading ...
Refer to the chart below should the unit not function properly. If' the problem you are experiencing is not listed below,
or if the instruction below does not help, set the unit to the standby mode, disconnect the AC power supply cable, and
contact the nearest authorized Yamaha dealer or service center. Check the below first.
1 The AC power supply cable of the unit, TV and external components (such as BD player) are firmly connected to
the AC wall outlet.
2 The power supply of' the unit, TV and the external components (such as BD player) are turned on.
3 All cables are firmly connected to their respective jacks on each component.
Power turns on but
immediately shuts oft'.
The speakers make no
sound,
Surround effect is not
achieved,
No bass / The external
subwoot'er makes no sound.
The power cable may be connected improperly. Make sure the power cable is plugged into the 4
outlet firmly.
The unit may have received a strong electrical Set the unit to standby mode, and then
shock, such as l_om a lightening boll or disconnect the power cable. Wait lk)l"about 30
excessive static electricity, seconds, connect the power cable, and then turn
the unil oil again.
The unit has an auto-sleep lkmclion, which will
lett turned on lk)r 12 hours without any
automatically set to standby mode if the unit is
operation being pertk)rmed.
Tile volume may be set to minimum.
The mute hmction may be activated.
The input source or input setting may be
incorrect.
A surround mode is ]lot selected.
Adjust the volume level.
Press MUTE on the Ivmote control to cancel the
mute hmclion and adjust the volume.
Select tile correct input source or input setting.
Press SURROUND on the remote control to
play back the source in surround effi:cl.
Adjusl the vohune level of lhe subwool)r.
8
8
7
7
8
8
5
Select collect setting ol subwooti_r.
Connect the unit and the external subwoofer by
using a subwooli?r pill cable.
The volume of the subwooler channel may be
set to minimuln level.
Opposite setting of subwooti:r is selected.
The source does ilol conlain low frequency
signals.
The cable between the unit and the subwooti:r
not connected when selecting playback of the
external subwooti2r.
The volume level decreases The uili[ controls its volume within a certain Reset the volume. 8
without any operation, level to prevent the next playback lrom sudden
output at excessive volume.
This unit does not operate The unit may ivceive a strong electrical shock, Set the unit to standby mode, and theli
properly, such as from a lightening bolt or excessive static disconnect the power cable. Wait lor about 30
electricity, or drop ill power supply, seconds, connect the power cable, and then mrn
on the unit again.
A digRal or high-frequency The unit may be placed close to digital Place the unit away from such equipment.
equipment produces noises, eqllipmenl or high-lrequency equipment.
The remote control does not The unit may be outside the remote coiItrol The operation range lor the remote control of 6
operate the unit. operation range, the unit is within 6 m (20 1i).
The remote control sensor of the unit may be Change the lighting or ivposition the unit.
exposed to direct sunlight or other lighting.
The batteries may be worn out. Replace tile batteries. 6
The Volume of the unit and "IV Your TV itself received the signal lrom TV Set the volume of your TV to minimum, or set
increases simultaneously, remote control, having learned the operation of the audio output of your TV builtqn speaker to
the unit. oil.
Adjust the volume by using the remote control 8
of the unit.
12 En
Loading ...
Loading ...
Loading ...