Loading ...
Loading ...
Loading ...
Ie]|J =_lil=II_l-_|l W±lil[o]_
This cutting tool is double insulated toprotect you from
electrical shock.
IAWAJ NINGI
Double insulated tools are equipped with a polarized
plug (one blade is wider than the other). This plug will
fit into a polarized outlet only one way. ffthe plug
does not fit fully into the outlet, reverse the plug. If it
still does not fit, contact a qualified eis_dcisn to
install a polarized outlet. [3o not alter the plug in any
way. Double insulation eliminates the need for the three
wire grounded power cord and grounded power supply
system.
Avoid body contact with grounded surfaces such as
pipes, radiators, ranges and refrigerators. There is an
increased risk of electric shock if your body is grounded.
Do not expose power tools to rain or wet conditions.
Water entedng a power tool will increase the risk of
electric shock.
Do not abuse the cord. Never use the cord to carry
the tool or pull the plug from the outleL Keep cord
away from heat, off, sharp edges and moving parts.
Replace damaged cords Immediately. Damaged cords
increase the dsk of electdc shock.
When operating a power tool outdoors, usa an
outdoor extension cord marked "W-A" or "W". These
cords are rated for outdoor use and reduce the risk of
electric shock.
IJ_ WARNING I
Always makesure the receptacle is polarized. Ifyou
are notsure, have a qualifiedelectriciancheckthe
receptacle.
Make sure your extension cord is in good condition.
When using an extension cord, be sure to use one heavy
enough to can/the current the toolwill draw. An
undersized cord will cause a drop in line voltage resulting
in lose of power and overheating. The table below shows
the correct size to use according to cord length and
nameplate ampere rating. If in doubt, use the next
heavier gauge. The smaller the gauge number the
heavier the cord.
Be sure your extension cord is properly wired and in
good condition. Always replace a damaged extension
cord or have it repaired by a qualified electrician before
usingit. Protect your extension cord fromsharp ct_jects,
excessive heat and damp or wet areas.
Use a separate electrical circuit for your power tools.
This circuit must not be less than 14 gauge wire and
should be protected with either a 15 Ampere time delay
fuse or circuit breaker. Before connecting the power tool
to the power source, make sure the switch is in theOFF
position and the power source is the same as indicated
on the nameplate. Running at lower voltage will damage
the motor.
IAWARNINGI
Repair or replace damaged or worn extension cords
immediately,
Select the appropriate extension cord gauge and length
using the chart below.
MINIMUM GAUGE(AWG)EXTENSIONCORDS
(120 Volt use only)
Ampere Rafing Total length in feet
Not
MoreThan MoreThan 25' 50' I 100' 150'
0 6 t8 16 16 14
6 10 t8 16 ] 14 12
10 12 t6 16 I 14 12
t2 16 t4 12 NotApplicable
IA WARNINGI
Keep the extension cord clear of the working area.
Peeltlon the cord so it will not got caught on the
workpiece, tools or any other obstructions while you
are working with the power tool.
Loading ...
Loading ...
Loading ...