Loading ...
Loading ...
Loading ...
IA WARNING)
For your safety, do not plug in your cutting tool or try
to use any accessory until it is completely assembled
and installed according to these instructions, and
until you have read and understood this Owner's
Manual.
Failure to follow these safety rules will result in risk of
serious Injury.
1. WEAR EYE PROTECTION. This high speed toolwill
throw particles from the workpiese dudng operation.
Make sure safety glasses have side shields.
2. USE FACE OR DUST MASK along with safety
goggles if cutting or muting operation is dusty, Make
sure work area is well ventilated,
3. USE HEARING PROTECTION, perticulady dunng
extended pedods of operation.
4. NEVER USE DULL OR DAMAGED BITS, Damaged
bits can break without warning. Dull bits may overload
the motor, cut slewiy and are difficult tocontrol. They
will also overheat and possibly break.
5. ALWAYS MAKE SURE THE WORKPIECE IS FREE
OF NAILS AND OTHER FOREIGN OBJECTS. If the
bit stdkes a nail it will jump sideways and possibly
break.
6. DO NOT USE THIS TOOL FOR DRILUNG HOLES.
It isNOT intended to be used as a ddlL
7. ALLOW CLEARANCE UNDER WORKPIECE for bit
to travel. Never place workplace on hard surfaces
such as concrete etc. The bit may jump or break when
contacting a surface other than the one being cut,
8. ALWAYS SET THE DEPTH GUIDE TO THE
APPROPRIATE DEPTH. Use tool with the depth
guide fiat against the work surface for better control of
the tool.
9. NEVER USE THE TOOL WITHOUT THE SOLE
pLATE, PRECISION HANDLE OR ROUTER BASE
attached and appropriately adjusted.
10. ALWAYS CLAMP WORKPIECE TO HOLD IT
S1T=ADYWHEN CUTnNG, This will free both hands
for operating the tool.
11.
12.
NEVER HOLD THE WORKPIECE IN ONE HAND
while operating the toolwith the other hand.
NEVER PLACE HANDS IN THE PATH OF THE
cUTrER AND UNDER THE WORKPIECE.
13.
t4.
t5.
NEVER START THE TOOL WHEN THE BIT IS
TOUCHING THE WORKPIECE. The bit may catch
the workplace causing loss of control,
ALWAYS HOLD THE TOOL WITH I_VO HANDS
DURING START-UP AND OPERATION. When
starting, motor torque will cause the tool to twist.
TURN OFF ALL CIRCUIT BREAKERS AND
REMOVE ALL FUSES inthe work area when cutting
into walls or blind areas.
16, ALWAYS HOLD THE TOOL BYTHE INSULATED
GRIPPING SURFACES ON THE BODY OF THE
TOOL where there is any possibilityof the cutting bit
contacting hidden electrical wires or the cord of the
tool. Contact with "live" wires will make exposed metal
parts of the tool "live" causing an electrical shock to
the operator.
17, WHEN CUTTING DRYWALL ELECTRICAL OUTLET
OPENINGS using the outlet as a guide, always cut in
a counter clockwise direction. The natural tendency of
the tool to pull to the left will cause a "hugging"action
toward the outlet box, resulting in a neatar cut.
18. NEVER LAY THE TOOL DOWN UNTIL THE
CUTTING BIT COMES TO A COMPLETE STOP. A
spinning bit can come in contact with the surface and
pull it out of your control,
19, NEVER TOUCH THE CUTRNG BIT IMMEDIATELY
AFTER USE. The bit will be too hat to be handled with
bars hands and will bum your fingers.
20,
ALWAYS RE-TIGHTEN COLLET AND ALL
ADJUSTMENTS before starting the too/after a cutting
bit or accessory has been changed. Loose bits and
adjustments can cause unexpected shiftingof the tool
resulting in loss of control and injuryfrom the bit or
cutting tool being thrown.
SAVE THESE INSTRUCTIONS FOR REFERENCE
4
Loading ...
Loading ...
Loading ...