Loading ...
Loading ...
Loading ...
Installation Instructions
ELECTRICAL REQUIREMENTS
Read these instructions completely and carefully.
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK AND
PERSONAL INJURY:
. DO NOT USE AN EXTENSION CORD OR AN ADAPTER
PLUG WITH THIS APPLIANCE.
Washer must be electrically grounded in accordance
with local codes and ordinances, or in the absence
of local codes, in accordance with the NATIONAL
ELECTRICAL CODE, ANSl/NFPA NO. 70.
CIRCUIT- Individual, properly polarized and grounded
15-amp branch circuit fused with 15-amp time-delay fuse
or circuit breaker.
POWER SUPPLY - 2-wire, with ground, 120-volt,
single-phase, 60-Hz, alternating current.
OUTLETRECEPTACLE- Properly
grounded 3-prong receptacle to be
located so the power supply cord
is accessiblewhen the washer is
inan installed position.
GROUNDING REQUIREMENTS
WARNING:
Improper connection of the equipment grounding conductor
can result in a risk of electrical shock.Check with a licensed
electrician if you are in doubt as to whether the appliance is
properly grounded.
1. The washer MUSTbe grounded. Inthe event of
malfunction or breakdown, grounding will reduce
the riskof electrical shock by providing a path of least
resistancefor electrical current.
2. Sinceyour washer isequipped with a power supply
cord having an equipment-grounding conductor and
a grounding plug, the plug MUSTbe plugged into an
appropriate, copper-wired receptacle that is properly
installedand grounded in accordance with all local
codesand ordinances or in the absence of local codes,
with the National ElectricalCodes,ANSI/NFPA70 (latest
edition).If in doubt, call a licensed electrician.DO NOT
cut off or alter the grounding prong on the power
supplycord. In situations where a two-slot receptacle is
present, it is the owner's responsibilityto have a licensed
electrician replace it with a properly grounded
three-prong grounding-type receptacle.
WATER SUPPLY REQUIREMENTS
Hot and cold water faucets MUSTbe installed within
42 inches (107 cm) of your washer's water inlet. The faucets
MUSTbe 3/4" (!.9 cm) garden hose-type so inlet hoses can
be connected. Water pressure MUSTbe between 10 and 120
pounds per square inch. Your water department can advise
you of your water pressure.The hot water temperature
should be set to deliver water at !20 ° to !40°F (48°-60°C).
DRAIN REQUIREMENTS
!. Drain capable of eliminating 17 gals (64.3 L)
per minute.
2. Astandpipe diameter of !-!/4" (3.!8 cm) minimum.
3. The standpipe height above the floor should be:
Minimum height: 24" (6! cm)
Maximum height: 96" (244cm)
I--
96"
(244 cm)
Max.
BACK
24"
(61 cm)
Min.
NOTE:The drain hose attached to the washer can reach
a 58" (!47 cm) high standpipe. For a higher standpipe,
contact an authorized parts distributor.
18
Loading ...
Loading ...
Loading ...