Loading ...
Loading ...
1x
green
3x
ball tip
red
Initiate the pairing process at your smart
home controller. Refer to your smart home
system instructions for more information.
Note: See supplied lyer for provider websites
and contact information as applicable.
When prompted by your smart home
system to initiate pairing at the lock, press
button “A” on the lock interior four times.
If the pairing process is successful, re-name
the lock in your system (if applicable).
If the pairing process is unsuccessful, press button
“B” nine times.
Perform steps 6A6C again.
If pairing is still unsuccessful, consult the SmartCode
914 Programming and Troubleshooting Guide online
at www.kwikset.com.
A B C
D
Pair the lock with your smart home system
Re-key the lock (if needed). Install the battery cover.
Conirm that the code(s) added in step 7 can unlock the door.
A B
One green lash with one beep Three red lashes with three beeps
or
IMPORTANT:
Remove battery
pack before
re-keying.
Make sure the door is open. Press
the Program button once.
Locking the Door Unlocking the Door
Enter user code. A total of 30 user
codes may be programmed.
Press Lock button once.
A B C
Did the keypad lash green once with one beep or lash red three times with three beeps*?
D
Each user code
must be a unique
code between
4 and 8 digits,
depending on
your smart
home system.
Programming was successful.
Proceed to step 8.
Programming was unsuccessful.
Make sure the user code is not a duplicate and that it is between
4 and 8 digits during your next attempt.
Make sure the lock has room for an additional code. If all user code
positions are illed, delete a code to make room for this one.
Press Lock button once. Enter user code.
It is recommended that you add and
delete all user codes through your smart
home control system. If your system
does not allow this, codes may be added
directly to the lock as shown here.
Mastercode
For enhanced security, a mastercode may
be used when adding and deleting user
codes. For more information about the
mastercode, download the SmartCode
914 Programming and Troubleshooting
Guide at www.kwikset.com.
Programming Timeout
During programming, if no button is
pressed for ive seconds, the system will
time out (indicated by three beeps and a
red lashing keypad), and you will need to
restart the procedure.
*Beeping sound will only be heard if switch #3 (on the lock interior) is in the on positon.
L
G
R (3x)
J
S
J
a a
b b
c
Re-key the lock
to work with your
existing key. See
the supplied
SmartKey Re-key
instructions for
more information.
Keep “G” in a safe place, as you will need it to access
the back panel for additional programming.
Reinstall
battery
pack.
6
7
8
9
Add user codes
Re-key the lock (if needed) and install the battery cover
Test the lock (review normal operation)
Loading ...