Loading ...
Loading ...
Loading ...
TROUBLESHOOTING
Most treadmill problems can be solved by following the simple steps below. Find the symptom that
applies, and follow the steps listed. If further assistance is needed, call toll-free 1-8O0-4-MY-HOME®
(1-800-469-4663).
PROBLEM: The power does not turn on
SOLUTION: a.
Make surethat the power cord is plugged intoa surge suppressor,and thatthe surge suppressor
ispluggedintoa propedygroundedoutlet(see page 8). Useonlya single-outletsurgesuppressor
that meets all ofthe specificationsdescribed on page 8. Important:The treadmillisnot compatible
with GFCl-equipped outlets.
b,
C.
After the power cordhas been plugged in, make sure that the key is fully inserted into the console.
Check the reset/off circuit breaker located on the
treadmillframe near the power cord. If the switch
protrudesas shown,the circuitbreaker has
tripped. To resetthe circuitbreaker, wait for five
minutesand then pressthe switchback in.
Tripped
Reset_
PROBLEM: The power turns off during use
SOLUTION: a. Check the reset/offcircuit breaker (see the drawing above). If the circuit breaker has tripped, wait
for five minutesand then pressthe switchbackin.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it,wait for
five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key fully into the console.
d. If the treadmill still will not run, please call toll-free 1-800-4-MY-HOME ®(1-800-469-4663).
PROBLEM: The incline of the treadmill does not change correctly
SOLUTION: a. With the key in the console, press one ofthe Inclinebuttons. While the incline is changing, re-
move the key. After a few seconds,re-insertthe key.The treadmillwillautomaticallyrise to the
maximumincline leveland then returntothe minimumlevel.Thiswillrecalibratethe inclinesystem.
PROBLEM: The console is too high ortoo low
SOLUTION: a. See assembly step 7 on page 7.
PROBLEM: The treadmill rocks during use
SOLUTION: a. See HOW TO LEVEL THE TREADMILL on page 20.
PROBLEM: The displays of the console do not function properly
SOLUTION: a. Remove the key fromthe console and UNPLUG THE
POWER CORD. Withthe helpof a second person,
carefullytip the UprightBase(97) down as shown.
Remove the five HoodScrews (44). Note:A phillips
screwdriverwith at leasta 5" shaftisrequired.
k _44,
_'_ t _"_ 44 '
22
Loading ...
Loading ...
Loading ...