Loading ...
Your safety and the safety of
others is very important.
We haveprovided many important
safety messagesin this manualand
on your appliance. Always readand
obey all safety messages.
This is the safety alertsymbol.
This symbol alertsyou to
potential hazardsthat can kill
or hurt you and others. All safety
messageswill follow the safety alert
symbol and either the word "DANGER"
or "WARNING".Thesewords mean:
Youcanbe killed or seriouslyinjured
if you don'tfollow instructions.
All safety messageswiil tell you what
the potential hazardis, tell you how to
reducethe chance of injury, andtell
you what can happenif the
instructions are not followed.
WARNING -- TO REDUCE THE
RISK OF FIRE, ELECTRIC SHOCK,
OR INJURYTO PERSONS,
OBSERVE THE FOLLOWING:
Installation work and electrical
wiring must be done by qualified
person(s) in accordance with all
applicable Codes and Standards,
including Fire Rated
Construction. The combustion
airflow needed for safe
operation of fuel-burning
equipment may be affected by
this unit's operation. Follow the
heating equipment
manufacturer's guideline and
safety standards such as those
published by the National Fire
Protection Association (NFPA),
and the American Society of
Heating, Refrigeration and Air
Conditioning Engineers
(ASHRAE), and the local code
authorities.
When cutting or drilling into wall
or ceiling, do not damage
electrical wiring and other
hidden utilities.
Ducted fans must always be
vented to the outdoors.
WARNING --To reduce the risk
of fire, use only metal ductwork.
This unit must be grounded.
Partsneeded:
2 U.L.- or C.S.A.- listed, 1/2" (12.5 mm}
conduit connectors
power supply cable
1wall or roof cap
metal vent system
6 screws to attach brackets to wall
Parts supplied:
top
bracket
middle
bracket
bottom
bracket
upper
chimney
__L
important: Observe all governing
codes and ordinances.
Proper installation is your
responsibility:
• Have a qualified technician install
this range hood.
• Comply with installation clearances
specified on the model/serial rating
plate.
The model/serial rating plate is
located inside the range hood on the
rear wall.
Range hood location should be away
from strong draft areas, such as
windows, doors and strong heating
vents.
Cabinet opening dimensions that are
shown must be used. Given
dimensions provide minimum
clearance. Consult your cooktop/range
manufacturer installation instructions
before making any cutouts.
Grounded electrical outlet is required.
See "Electrical requirements."
The canopy hood is factory set for
venting through the roof or wall. For
non-vented (recirculating)installations
see "Non-Vented (Recirculating) Kits"
on the back page.
All openings in ceiling and wall where
range hood will be installed must be
sealed.
Tools needed:
level drill
1-1/4" drill bit
measuring
tape or ruler
wire stripper
or utility knife
caulking gun and
weatherproof
caulking
compound
duct talc
damper
screwdriver
saber or
keyhole saw
screwdriver
Loading ...
Loading ...
Loading ...