Loading ...
Loading ...
Loading ...
esatto.house
13
Defrosting
The bar fridge requires manual defrost. For ecient operation and minimum energy consumption, defrost
the chilling compartment when the frost on the chiller walls is building up. Do not let frost build up to more
than 3–4mm thickness. For eciency, choose a time when your stock of frozen food is low.
• Unplug the power cord
• Please remove the foods from the refrigerator and place them properly to prevent foods from melting or
going bad, then prepare a water container for holding defrosting water.
• Pour the water in drain tray into the water container, and it is recommended to use a dry towel to dry the
defrosting water on liner and evaporator, then wring dry the towel. Repeat the operation until defrosting
completed.
• You can use the natural temperature of the natural defrosting, you can also use the ice shovel to eliminate
the frost (to use plastic or wooden ice shovel to prevent damage to the liner)
• You can also use the appropriate amount of hot water to speed up defrosting, with the dry towel to dry the
water after defrosting.
• Put all foods back and power on the appliance again.
Cleaning
WARNING
Before cleaning the appliance, make sure it is switched o and disconnected from the power supply.
Failure to do so can result in electric shock or injury.
• Wash the inside surfaces and the interior accessories with a damp, warm cloth moistened in a water and
baking soda solution. The solution should be about 2 tablespoons of baking soda to 1 litre of water. Rinse
and wipe dry with a soft cloth.
• Clean the outside of the unit with a damp, well wrung out cloth, keeping the area of the controls dry. Keep
the lid gasket (seal) clean.
• Never use boiling water to accelerate defrosting as it may damage the plastic components.
• Regularly check the appliance for defrost water. If necessary, clean the drain. If the drain is blocked, water
will collect in the base of the appliance.
• After cleaning/defrosting, push the drain plug in.
• After everything is dry, place appliance back into service.
• Allow approximately 1–2 hours for the cabinet to cool down again (depending on the length of time the
appliance was disconnected from the power).
WARNING
Never clean the unit with an abrasive, acid, oil or solvent based cleaning agent. Never use ammable uids
or sprays for cleaning as the fumes from these substances can create a re hazard or Explosion.
Mintennce nd Clening
Loading ...
Loading ...
Loading ...