Loading ...
Loading ...
Loading ...
To confirm ACC signal, Ignition Switch position must be in ACC position. You
should get voltage reading on multimeter or light up on circuit tester. Reconfirm the
fuse slot again with Ignition Switch position in Lock position and recheck the fuse
slot using multimeter or circuit tester. You should not get any voltage reading on
your multimeter or circuit tester not light up during Ignition Switch in Lock
position.
To confirm ground point, refer to below picture; use multimeter to check continuity
mode. Find any screw direct tighten to vehicle body and measured the screw point
against the vehicle body. A good ground point must get continuity reading at < 0.1
ohm.
Loading ...