Loading ...
Loading ...
Loading ...
- 4 -
1. TO TAKE STANDARD MEASUREMENTS:
Press button ' to take the measurement. The result will be displayed unless an error has
occurred in which case try again.
2. TO ADD RESULTS: (without using the memory)
Press button ' to take the measurement. Press button ( to enter the addition mode.
The '+' is displayed on the LCD. Press button ' again to take the next reading. Press
button ( to display the result.
3. TO ADD RESULTS: (using the memory)
Press button ' to take the measurement. Press button ) to save the current
measurement. Press button ' to to take the next reading. Press button ( to enter the
addition mode. The '+' is displayed on the LCD. Press button * to recall the previous
measurement. Press button ( to display the result.
4. TO TAKE AREA MEASUREMENTS:
Press button + to enter area mode. The symbol will appear on the LCD with the 'L'
flashing. Press button ' to take the length measurement. If the measurement was
successful the 'W' will begin flashing. Press button ' to take the width measurement. If
successful the result in Ft
2
/M
2
will be displayed under the individual measurement button
' to cycle through the two individual measurements or press button + to begin a new
area measurement. Alternatively, press and hold button ' for two seconds to exit the
area mode.
NOTE: It is possible to store an area result in the memory, take a fresh area measurement
and add them together using button (.
5. TO TAKE VOLUME MEASUREMENTS:
Press button , to enter volume mode. The symbol will appear on the LCD with the 'L'
flashing. Press button ' to take the length measurement. If the measurement was
successful the 'W' will begin flashing. Press button ' to take the width measurement. If
successful the 'H' will begin flashing. Press button ' to take the height measurement. If
successful the result in Ft
3
/M
3
will be displayed under the individual measurement. Press
button ' to cycle through the three individual measurements or press button , to
begin a new volume measurement. Alternatively, press and hold button ' for two
seconds to exit the area mode.
NOTE: All length, width and height measurements must be complete to exit the volume
mode.
NOTE: It is possible to store a volume result in the memory, take a fresh volume
measurement and add them together using button (.
OPERATION AND USE
Loading ...
Loading ...
Loading ...