Loading ...
Loading ...
Loading ...
5
OPERATIONS MANUAL
REACH-INS & ROLL-INS
Four (4) bolts secure the cabinet to the wooden skid. The bolts
are located at each end on the underside of the skid. In order to
remove these bolts, tilt the cabinet backwards and place wood-
en blocks at each end in order to hold it in its tilted position.
Using a ¾” socket or open end wrench, remove the bolts and
carefully slide the cabinet off of the skid. If caster support plates
are to be installed, save the bolts and washers (see “Mounting
Caster Support Plates” under “Optional Accessories”).
After skid removal, the cabinet should never be moved without
dollies or rollers to avoid damage to the cabinet bottom or floor.
IMPORTANT NOTE: Do not under any circumstances, lay
your new model on its front or sides. For a brief period
of time, you may lay the cabinet on its back, but only
when it’s properly blocked so as not to crush the back
or end panels and also to allow provision for your hands,
in order to set it in its upright position without damaging
the cabinet. Do not plug in and operate model for at
least three (3) hours after cabinet is set upright from
being on its back as this can damage the compressor.
MODEL COMPONENTS
FIGURE 2A: Designer Line Reach-In or Pass-Thru
Refrigerator or Freezer
FIGURE 2: Standard Reach-In Refrigerator or Freezer
Standard Reach-In refrigerators and freezers have an internal
evaporator coil located behind the fan panel on the inside ceil-
ing of the refrigerated compartment (see Figure 2). Designer
Line Reach-In, as well as all Pass-Thru, Roll-In and Roll-Thru
refrigerators and freezers have an insulated housing located on
top of the cabinet, that contains the evaporator coil, out of the
refrigerated storage area (see Figure 2A & 2B).
All warmers have an insulated housing located on top of the
unit, that contains a blower fan to circulate warm air inside the
cabinet (see Figure 2C). On most models, the high-wattage,
finned electric heating elements are located inside the cabinet,
at the bottom of the interior side walls. On single-section Roll-In
and Roll-Thru models, the heating elements are located in the
housing on top of the unit, to optimize space for carts inside
the cabinet.
Loading ...
Loading ...
Loading ...