Loading ...
Loading ...
Loading ...
© 2020 United States Stove Company
7
INSTALLATION
This heater must have a non-combustible oor
protector with a minimum type 1 ember protection
extending beneath the heater if the oor is
constructed of combustible material. If a oor pad
is used, it should be UL listed or equal. The oor
protector should be large enough to extend under
the stove and beyond each side as indicated. If
there is a horizontal run of ue pipe, there needs to
be oor protection under it that extends two inches
beyond either side of the pipe.
CLEARANCES TO COMBUSTIBLES
It is of utmost importance that the clearances to
combustible materials be strictly adhered to during
installation of the stove.
• Floor to ceiling height must be at least 7’ (2.13 m)
in all cases.
• Do not place any combustible material within 4’
(1.2 m) of the front of the unit.
• The clearance between the ue pipe and a wall
are valid only for vertical walls and for vertical ue
pipe.
• The chimney connector must not pass through
an attic or roof space, closet or similar concealed
space, a oor, or a ceiling.
• For Canadian installations, where passage through
a wall, or partition of combustible construction is
desired, the installation must conform to CAN/
CSA-B365.
• A ue pipe crossing a combustible wall must have
a minimum clearance of 18” (458 mm).
• To reduce ue clearances from combustible
materials, contact your local safety department.
• The provision that clearances may only be reduced
by means approved by regulatory authority.
A
B
F
E
C
D
G
J
H
Key in mm
A Sidewall To Flue 23 585
B Sidewall To Stove 14 356
C Ceiling Height 84 2134
D Top Of Stove To Ceiling 50.5 1283
E Back Wall To Flue 18 458
F Back Wall To Stove 28 712
G
Wall To Corner (Angled
Installation)
18 458
H
Wall To Corner Fuel Loading Side
(Angled Installation)
18 458
J Wall To Flue (Angled Installation) 18 458
OUTSIDE COMBUSTION AIR
Your wood stove is approved to be installed with
an outside air intake (4FAK) which is necessary
for a mobile home. This type of installation is
also required in air tight houses and houses with
negative pressure problems. You can purchase this
option through your heater dealer. Make sure to
specify the part number mentioned in this booklet.
Installation instructions are supplied with the air
intake kit. Outside combustion air may be required
if:
1. Your stove does not draw steadily, smoke roll-out
occurs, wood burns poorly, or back-drafts occur
whether or not there is combustion present.
2. Existing fuel-red equipment in the house, such
as replaces or other heating appliances, smell,
do not operate properly, suffer smoke roll-out
when opened, or back-drafts occur whether or
not there is combustion present.
3. Opening a window slightly on a calm (windless)
day alleviates any of the above symptoms.
4. The house is equipped with a well-sealed vapor
barrier and tight tting windows and/or has any
powered devices that exhaust house air.
Loading ...
Loading ...
Loading ...