Loading ...
Loading ...
Loading ...
4
© 2020 United States Stove Company
UNPACK AND INSPECT
Remove the packing from the appliance and
inspect for any damage. Ensure that the bricks are
positioned correctly and not broken (see illustration
for proper brick arrangement). Make sure that the
bafe board, above the air tubes, is in place and
undamaged.
BLOWER ASSEMBLY
The blower assembly must be disconnected from
the source of electrical supply before attempting
the installation.
1. Remove the Panel (A) using tin snips or knock
out using a hammer and chisel careful not to
distort the mounting surface.
2. Attach the Blower Mounting Box (B) to the rear
of the unit using four(4) of the supplied #10
screws.
3. Then mount the Blower Assembly (C) with the
four (4) remaining screws.
CABINET DOOR KNOB ASSEMBLY
The cabinet door knob is mounted on the inside of
the cabinet door for shipping purposes and must be
removed and re-installed for proper usage. To get
the cabinet door open, place your hand under the
cabinet frame (right-hand side of the cabinet door)
and pull out on the door. Follow these instructions
for door knob assembly:
1. Remove the machine screw and the door knob.
2. Place the knob on the outside of the cabinet
door, re-install the machine screw and tighten.
Be careful not to strip out the threads in the
handle.
MACHINE
SCREW
CABINET DOOR
KNOB
HANDLE & FEED DOOR OPERATION
1. Lift the handle up to disengage the latch.
2. Crack open the feed door for approximately 10
seconds to allow excess heat to escape.
3. After approximately 10 seconds lower the handle
and continue to pull the door open.
ASSEMBLY INSTRUCTIONS
Loading ...
Loading ...
Loading ...