Loading ...
Loading ...
Loading ...
50 51
50 51
2. Install the dado table insert making
sure that the rear of the insert is
flush with the table. If the dado
insert is not flush with the table,
adjust the two bolts on the insert
with a 4 mm hex wrench until it is
parallel with the table.
3. Instruction for operating the dado
is packed with the separately
purchased dado set (not included
with unit).
4. The arbor (1) on this saw restricts
the maximum width of the cut to
1/2 in. (Fig. kk)
5. It is not necessary to install the
outside flange (2) before threading
on the arbor nut (3) for the
maximum 1/2 in. dado cuts. Make
sure that the arbor nut (3) is tight,
and that at least one thread of the
arbor sticks out past the nut.
6. Use only the correct number of
round outside blades and inside
chippers as shown in the dado set’s
instruction manual. Blade or
chippers must not exceed 1/2 in.
total in width.
7. Check the saw to ensure that the
dado will not strike the housing,
insert, or motor when in operation.
Fig. kk
2
1
3
F
or your own safety, always replace
the blade, blade guard assembly,
anti-kickback pawls assembly, riving
knife assembly and table insert when
you finish the dado operation.
WARNING
!
Fig. ll
Dado cut
Loading ...
Loading ...
Loading ...