Loading ...
Loading ...
Loading ...
ADJUSTING DEPTH OF CUT FOR FIXED BASE
ROUTERS
See Figures 11 - 13.
[] Unplug the router.
[] Place the fixed base on a flat surface.
[] Loosen the locking arm.
[] Turn the depth adjustment ring counterclockwise until
the tip of the cutter touches the work surface.
[] Turn the depth indicator ring until the zero lines up with
the indicator point on the base.
LOCKINGARM
Fig. 13
TURNING THE ROUTER ON AND OFF
See Figure 14.
To turn the router on, push the switch to the (I) or on
position. Return the switch to the ( 0 ) or off position
when routing operation is finished.
Fig. 11
[] Position the router so that the cutter can extend below
the subbase for desired depth of cut.
[] Turn the depth adjustment ring to the desired depth of
cut.
[] Tighten the locking arm securely.
NOTE- To adjust the depth of cut when the router is
mounted to a router table, turn the depth adjustment
ring until the cutter reaches the desired depth of cut.
INDICATOR
POINT
INDICATOR
RING
ON
OFF
Fig. 14
Fig. 12
14
Loading ...
Loading ...
Loading ...