Loading ...
Loading ...
Loading ...
Keep your refrigerator and freezer clean to prevent odor
build-up, Wipe up any spitls immediately and clean both
sections at least twice a year, Never use metallic
scouring pads, brushes, abrasive cleaners or strong
alkaline solutions on any surface_ Do not wash any
removable parts in a dishwasher_
Always unplug the power cord from the wall outlet
before cleaning.
NOTE: Turning the control to OFF does not disconnect power
to the controls, light butb. or other electrica! component&
Damp objects stick to cold t
metal surfaces. Do not touch refrigerated I
surfaces with wet or damp hands,
INSIDE
Wash inside surfaces of the refrigerator and freezer with a
solution of 2 tablespoons baking soda in 1 quart warm
water, Rinse and dry thoroughly Be sure to wring excess
water out of sponge or cloth before cleaning around the
controls, light bulb, or any electrical parts.
Wash removable parts such as shelves and drawers with
baking soda solution or mild detergent and warm water Do
not use harsh cleaners on these surfaces_ Rinse and
dry thoroughly Clean the door gaskets with mild suds,
rinse with clear water and wipe dry,
Do not use razor blades or other sharp instruments which
can scratch the appliance surface when removing adhesive
labels Any glue left from the tape or energy label can be
removed with a mixture of warm water and mild detergent,
or. touch the glue with the sticky side of tape a#eady
removed. Do Not removethe serial plate.
OUTSIDE
Wash the cabinet and handles with warm water and mild
liquid detergent, Rinse well and wipe dry with a clean soft
cloth Do not use commercial household cleaners,
ammonia, or alcohol to ctean handles,
Clean stainless steel (some models) front and handles
with hot soapy water and a dishcIoth. Rinse with clean
water and a soft cloth. Wipe stubborn spots with an
ammonia-soaked paper towel, and rinse_ Cleaners made
especially forr stainless steel, such as Sheila Shine,
trademark of Sheila Shine, inc. Stainless Steet Magic,
trademark of Magic American Corp,, or similar products
are suggested AIways follow manufacturer's instructions.
Wash the rest of the cabinet with warm water and mild liquid
detergent, Rinse welt, and wipe dry with a clean soft cloth,
Remove any dust or dirt from the front of the toe grille using
a vacuum cleaner with its dusting toot attachment, Remove
the toe grille by pulling it straight ouL While the grille is
removed, vacuum the backside of the grille and wipe with a
sudsy cloth or sponge.
12
To avoid damage and help
the refrigerator run as efficiently as
possible, clean the condenser and air
vents periodically
Periodically clean the condenser (black tubes and wires
beneath the refrigerator, behind the toe grille), Do not allow
lint or dust to accumulate on the coils insert a long handled
brush or vacuum attachment between the two coils to bring
the tint forward To replace the toe grille, line up tabs with
holes and push grille straight on,
_ Use caution when
cleaning in the area of the coifs_
Surfaces there may be sharp
The air vents on the lower access panel at the rear of the
refrigerator should be cleaned periodically. Clean the vents
by using a vacuum cleaner with its dusting toot attachmenL
When moving the refrigerator, pull straight out, Do not shift
the refrigerator from side to side as this may tear or gouge
the floor covering Be careful not to move the refrigerator
beyond plumbing connections,
Vents
Air Vents on Lower Access Panels
REPLACING THE LIGHT BULB
To replace the light bulb in either compartment:
1 Unplug refrigerato_
2,, Wear gloves as protectio_ against possible broken glass,
3, Replace otd bulb with an appliance bulb of the same
wattage
4, Remember to plug refrigerator back in_
Ughl Shiefd
pTo
Remove
Removing Cdsper Ugh_ Shield end Bulb (some models)
Loading ...
Loading ...
Loading ...