Loading ...
Loading ...
Loading ...
10 ENGLISH
Adjusting the shaft length
WARNING:
• Beforeadjustingtheshaftlength,releasethe
switch trigger and remove the battery cartridge
from the string trimmer. Failure to release the
trigger and removing the battery cartridge may
causeapersonalinjury.
1
2
►1. Shaft 2. Grip
Toadjustthelengthoftheshaft,turnthegripcounterclockwiseuntil
the shaft is unlocked and pull out or push in to the desired length.
Nylon cutting head
NOTICE:
• The bump feed will not operate properly if the
Nylon cutting head is not rotating.
1
►1. Nylon cutting head
The nylon cutting head is a single string trimmer head
provided with a bump & feed mechanism.
To cause the nylon cord to feed out, the cutting head
should be bumped against the ground while the tool is run-
ning. As the nylon cord is feeding out it will automatically
be cut to the proper length by the cutter on the guard.
NOTE:
• If the nylon cord does not feed out while bump-
ing the head, rewind/replace the nylon cord
by following the procedures described under
“Installing or removing the Nylon cutting head”
and "Winding a new Nylon cord on the spool."
• Do not bump the tool to the concrete or asphalt
surface.Bumpingtothiskindofobjectsmay
cause the tool damage.
ASSEMBLY
WARNING:
• Always be sure that the tool is switched
o and battery cartridge is removed before
carrying out any work on the tool. Failure to
switchoandremovethebatterycartridgemay
resultinseriouspersonalinjuryfromaccidental
start-up.
• Never start the tool unless it is completely
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injuryfromaccidentalstart-up.
Installing the front grip
1
2
3
►1. Front grip 2. Clamping nut 3. Hex bolt
Put the front grip on the front grip holder and secure it
with a hex bolt and the clamping nut provided with the
stringtrimmerasshowninthegure.Atthistime,the
hex bolt needs to be installed from the side in which the
hex bolt lock port is located and the clamping nut needs
to be installed from the opposite side.
NOTE:
• The front grip has a edge-to-edge cut slit in its
mounting area. Using this slit allows you to eas-
ily install the front grip on the front grip holder.
Thefrontgripangleisadjustable.Toadjustthefront
grip angle, loosen the claming nut, set the front grip at
an proper angle according to your work and then tighten
thenutclockwisermly.
Loading ...
Loading ...
Loading ...