Loading ...
Loading ...
Loading ...
Page 12
MAINTENANCE
The scraper is located at the base of the
snow shovel beneath the auger housing.
1. Remove the battery pack from the tool.
2. Using a PH2 screwdriver (not included),
detach the scraper cover by removing
the 3 cover screws (FIG. 6a).
3. Detach the scraper by removing the 6
scraper screws (FIG. 6b).
4. Install the new scraper and the scraper
cover and fasten them securely to the
snow shovel with all screws in reverse
order.
STORAGE (FIG. 7)
FIG. 7
Storage Bag
Middle Pole
Assembly
1. Remove the battery pack from the
cordless snow shovel before storing.
Store the battery pack at room
temperature out of the reach of children.
2.
Decrease the middle pole length to the
minimum by following instructions in
chapter “ADJUSTING THE POLE LENGTH”.
3. Fold the auxiliary handle as described in
chapter “HANDLE ADJUSTMENT”.
4.
Disconnect the poles as described in
chapter “DISCONNECTING THE POLES”.
5. Place two assembly parts into the
storage bag.
6. Store the cordless snow shovel indoors
in a locked, dry place out of the reach of
children to prevent unauthorized use or
damage.
BEFORE EACH USE
1. Check for damaged, missing, or worn
parts.
2. Check for loose screws, misalignment
or binding of moving parts, or any other
condition that may affect the operation.
3. If abnormal vibration or noise occurs,
turn the tool off immediately and have
the problem corrected before further
use.
REPLACING THE
SCRAPER (FIG. 6)
FIG. 6a
Cover Screws
Scraper Cover
FIG. 6b
Scraper
Scraper
Screws
Lower Pole
Assembly
Loading ...
Loading ...
Loading ...