Loading ...
9
B) Continuous external draining
If the appliance is to be operated for long periods
but you are unable to empty the tank regularly,
you are recommended to use the continuous
drain facility.
1) Remove the protective cap 1 by turning it anti-
clockwise then remove the rubber cap 2 from
the spout (fig. 2).
2) Insert the protective cap 1 on the condensate
drain hose (8) as far as it will go (fig. 3), then
screw the protective cap back onto the spout
(fig. 4).
3) Make sure the end of the hose is no higher
than the spout (fig. 5) or water could remain
in the tank. Make sure there are no kinks in
the hose.
Please note:
Keep the rubber cap to close
the spout when the continuous drain function is
not in use.
C) Continuous drain with pump (cer-
tain models only)
Thanks to the exclusive condensate drain system,
the hose (9) can be used to drain condensate with
a difference in level of up to 4 m between the end
of the hose and the outlet.
For pump assisted drainage, connect the hose
provided (9) to the connection on the bottom of
the appliance (fig. 6). Select the dehumidifying
function and press the pump button.
Please note: If the condensate hose is not in
place and the pump is enabled, the message
PUMP will flash. To eliminate the problem:
• Check that the hose is correctly positioned
• Unplug the appliance from the mains and plug
in again
1
2
fig. 2
fig. 3
1 PUSH
2
fig. 6
EN
fig. 1
NO
NO
YES
fig. 5
fig. 4
INSTALLATION
Position the appliance in the room to be dehu-
midified.
A free space of at least 50 cm must be left at the
front of the dehumidifier, so as not to block the air
outlet.
For efficient ventilation a space of about 5-10 cm
should be left at the back of the appliance.
The condensate can be drained in three ways:
A)) Draining into the ta
The condensate can be drained directly into the
tank.
The tank can be easily removed (fig.1).
When the tank is full, remove and empty into a
sink or bath, then put back correctly.
Please note: The tank must be positioned cor-
rectly. An intermittent beep means the tank is not
correctly positioned.
Loading ...
Loading ...
Loading ...