Loading ...
Loading ...
Loading ...
SERVICE AND ADJUSTMENT
HOW TO
REPLACE THE DRIVE BELT
To replace the ddve belt, the trimmer head
and shield must be removed as follows.
A WARNING: Before you remove
the drive belt, disconnect the wire
from the spark plug.
1. Remove the two fasteners that hold the
rear of the shield to the trimmer housing
(See Figure 17).
2. Remove the four fasteners that hold the
front of the shield and trimmer head to
the trimmer housing.
3. Remove the %P pulley from the idler
bracket.
4. Raise the front of the trimmer housing
and remove the drive belt. On some mod-
els, it is necessary to loosen the mount-
ing belt for the drive pulley to remove the
drive belt (see Figure 18). Do not bend the
belt guides,
NOTE: Makesure you replacethe drive
belt only with a replacement belt from
the factory.
5. To assemble the drive belt, reverse the
above steps. Make sure all fasteners are
tight. Make surethe mounting belt for the
drive pulley is light.
6. Check the routing of the drive bell Make
sure the drive belt is inside of all belt
gulden shown in Rgure 18.
IMPORTANT: Test the drive system. Start
the engine and move the throttle control to
the FAST position. Engage and disengage
the trimmer head several times. When dis-
engaged, make sure the trimmer head com-
pletely stops when rseUng on the ground. If
the trimmer head continues to rotate, take
the trimmer to the nearest Sears Service
Center.
F-000210M 17
Loading ...
Loading ...
Loading ...