Loading ...
Loading ...
Loading ...
LED FUNCTIONS OF CHARGER (Fig. 3)
BATTERY RED GREEN
LED INDICATOR ACTION
PACK LED LED
Charging will beginHI/LO TEMP. Hot/Cold On Off when battery returns to
(SEE MANUAL) battery
32°F (0°O)-104°F (40°0)
DEFECTIVE _ Battery pack or
BATTERY Defective Flashing Off Charger/Adapter is
defective
BATTERY _ Charging Off Flashing Charging
CHARGING
BATTERY _ Fully Charging is complete
FULL charged Off On Maintenance charging
CHARGING A HOT BATTERY PACK
If the battery pack is above normal temperature range, the red LED will illuminate
and the green LED will be off. When the battery pack cools down to approxi-
mately 104°F (40°C), the charger will automatically begin charging.
CHARGING A COLD BATTERY PACK
If the battery pack is below the normal temperature range, the red LED will illu-
minate and the green LED will be off. When the battery warms to a temperature
of more than 32°F (0°C), the charger will automatically begin charging.
DEFECTIVE BATTERY
If the charger detects a problem, the red LED will begin flashing and the green
LED will be off.
1.
2.
3.
If registering as defective, remove and reinsert the battery pack in the charg-
er. If the LED status reads "defective" a second time, try charging a different
battery pack.
If a different battery pack charges normally, dispose of the defective battery
pack (see Maintenance section).
If a different battery pack also indicates "defective," the charger may
be defective.
BATTERY CHARGING
If the battery pack is being charged within a normal surrounding temperature
range (32 F to 104 F), the green LED will begin flashing and the red LED will be
off. The battery pack will reach a full charge in 30 minutes.
BATTERY FULL
If the battery pack is within normal temperature range, the green LED will illuminate
and the red LED will be off. The battery pack is fully charged and ready to use. The
battery pack will fully charge, but will not overcharge, if left on the charger.
NOTE: Charger may warm with several continuous charge cycles. This is part of
the normal operation of the charge. Charge in a well ventilated area.
TO ATTACH BATTERY
PACK (Fig. 4)
1. Make sure that the Drill
is "OFF"
2.
Align the raised rib on
the battery pack with the
grooves of the Drill, and
then attach the battery
pack to the Drill.
NOTE: Make sure that the latch
on the battery pack snaps into
place and the battery pack
is secured to the tool before be-
ginning operation.
Fig. 4
/
t
TO DETACH BATTERY PACK (Fig. 4)
1. Lock the trigger switch on the Drill by placing the direction of rotation (for-
ward/reverse/center lock) selector in center position.
2. Depress the battery release buttons located on the both sides of the battery
pack to release the battery pack.
3. Pull the battery pack out and remove it from the tool.
CAUTION: When placing the battery pack in the tool, be sure that the
raised rib on the battery pack aligns with the groove inside the Drill and the
latches snap into place properly. Improper assembly of the battery pack can
cause damage to internal components.
_L. WARNING: Battery tools are always in operating condition. Therefore,
the direction-of-rotation selector should always be locked when not in use or
carrying at your side.
10003 ManuaLRevised_08 0724 Page 18 10003 ManuaLRevised_08 0724 Page 19
Loading ...
Loading ...
Loading ...