Loading ...
Loading ...
Loading ...
18
www.fhiaba.com · www.thevettagroup.com · Info Line 1-855-4-FHIABA (1-855-434-4222)
>
q
ollowing the corresponding table, mark the
external and then the internal hole [ 3 ].
> Position the brackets on each set of marks to
make sure they are aligned [ 4 ], if you choose to
drill small pilot holes for the screws pay special
attention to not pass through the panel entirely.
[ 5 ].
> Screw the brackets in place [ 6 ].
Drawer Panel
> When preparing the Drawer Panel, follow the
same instructions as per the door panel, but
make sure measurements are taken starting
from the top edge [ 7 ].
The height-adjustment support brackets are
oriented the opposite way [ 8 ] (note imgs 4 and
8).
8
7
65
4
3
9
> Prepare the appliance door (and drawer(s) if
applicable) for panel mounting by threading the
shoulder bolts into the recessed receivers and
the set screws into the other hole
[ 9 ]. Ensure
the end with the hex key socket is threaded into
the door and not on the visible end. Thread this
in far enough that it is flush with appliance door
face so as not to interferece with hanging the pa-
nel. You will adjust these later from the inside of
the door and / or drawer.
5. PANELS MOUNTING
Loading ...
Loading ...
Loading ...