Loading ...
Loading ...
Loading ...
Aboutthe automatic icemaker.
A newly installed refrigerator may take 12to 24 hours to begin making ice.
On dispenser models, to Automatic Icemaker
access ice or reach the
power switch:
o Lift flTebin, flTenpull it
forward until the bin stops.
Lower the bin to access ice
or reach the power switch.
NOTE:In order to take full advantage
of the tilt-out ice bhT,only store items
on the shelf below the ice bin ttTat
are no taller than the Iowest poh?t
on the bhT.
The icemaker will produce seven cubes
per Q'cle--approximately ] 00-130 cubes
in a 24-hour period, depending on fl'eezer
coi/ll)}ii'tlllent [ei/ll)ei';ittli'e _ i'OOill
temperature, number of door openings
and other use conditions.
If the refrigerator is operated before the
water connection is made to the icemakeL
set the power switch in the O (off) position.
_._]_en the refl_igerator has been connected
to the water SUl)ply, set the power switch to
the I (on) position.
The icemaker will fill with water when it
cools to 15°F (-10°C). A newly inst;dled
reiiJgerator may take 12 to 24 h otu_ to begin
making ice cubes.
_Am will hear a buzzing sotmd each time
the icemaker fills with water:
Throw away the fi_t few batches of ice to
allow the water line to clea_:
Be sure nothing inte_feres with the sweep
of the feeler amL
\._]_en the bin fills to the level ot the teeler
am_, the icemaker will stop produdng
ice. It is nomml tor several cubes to be
joined mgethei:
If ice is not used fi'equenfl 5 old ice cubes
will become cloudy, taste stale and shrink.
Special notes about dispenser models:
Dispenser models have a tilt-out ice bin.
The bin can be tilted out as shown in
the ilhlstrations, and it will hold itself
up while you take ice out or mrn the
icemaker power switch on and off.
Be sure to put the bin back in place
before closing the doo_:
To restore your ice level from an empty
bucket stage, the following steps are
recommended:
O 12 hom_ after the fiI_t batch of ice
has fidlen into the bin, dispense
3 to 4 cubes.
@ _M*eI" an additional 6 hom_, dispense
3 to 4 cubes again.
These steps will restore your ice level
in fl_e shortest amount el time.
NOTE"/nhomes with lower-than-average water
pressure, youmay hearthe icemakercyclemultiple
times when mak/hgone batch of ice.
o Lift the bin, then pull it
forward until the bin stops.
Removing Ice Bin (dispensermodels)
CAUTION: The ice bin is heavy when full.
Set the power switch to the 0 (off) position
beli)re removing the bin.
When replacing the bin, be sure to press it
firefly into place. If it does not go all the
way l£ack, remove it and rotate the drive
mechanism 1/4 turn. Then push the bin
back again.
Dispenser Models on v
Lift and pull forward again
to remove the bin.
12
Loading ...
Loading ...
Loading ...